Request For Quotation Building Materials For The Talgar Central Bank

Grinding Grater Grater For Grinding With A Metal Clamp, 105X230mm. Made Of Very Durable Plastic With A Rubber Coating. The Metal Clip Fixes The Abrasive Mesh Or Paper. It Is Used For Grinding Various Surfaces. Article-3569-08 The Size Is 80*230Mm, Gost 18277-90. Fabric-Based Sanding Pad Has A Low Clogging Rate. Cutting The Sheet Into Pieces Of The Required Size Allows You To Use A Sandpaper On An Electric Tool With A Clamp. . Grain Size-320R The Length Is 20 M Width-20 Cm, Gost 28456-90 Nail Dowel The Nail Dowel Is Used For Through-Mounting Of Frames, Rails, Cable Channels, Pipe Clamps, Metal Crates, Cornices, Gvl Plates And Plasterboard To Concrete And Brick. The Main Advantage Of The Ego Is The Speed Of Installation, Since During The Production Of Works It Is Only Necessary To Drive A Screw Into The Dowel, Without Screwing The Ego. In Places Where It Is Difficult To Use A Hammer, You Can Use A Screwdriver With The Maximum Possible Slot Grip. Size: 6*40. In A Package: 100 Pcs., Gost R 52868-2007 Directorate For Plasterboard • Direct Suspension (Directorate) Is Used For Fastening The Ceiling Profile Of Gkl To The Surface. The Suspension Itself Is Fixed With A Dowel Or Anchor Bolt, The Ceiling Profile Is Attached To The Suspension With Self-Tapping Screws., Gost 12995-82 Guide Profile • Size: 50*40Mm • Length: 3 M • A Metal Guide Profile Is An Integral Element In The Construction Of Frames For Sheathing With Plasterboard Sheets. It Acts As A Guide For Rack Profiles, And Is Also Used As A Bridge Between Rack Profiles. The Element Is Made On Profile Bending Equipment From Galvanized Steel Tape With A Thickness Of 0.45 Mm. The Product Is Resistant To Deformation, Shows Durability And A Long Service Life, Is Not Subject To Corrosion Processes, Withstands Temperature Changes And Aggressive Environmental Influences. The Shelves (Side Parts) Of The Product Are Smooth, And The Main Wall Is Reinforced With Grooves For Rigidity., Gost 28943-91 Fittings For Metal Entrance Doors In A Set Metal Case Height-18.5 Cm Length-8 Cm Width - 2.5 Cm Article Number: 79080