Request for Proposal For Provision Of Construction Work In Mags Base

Request for proposals are invited for Provision of Construction Work in MAGs Base, Chawrta Masonary: Build a 20cm width cinder block surrounding walls inside each of the excavated pits, 4mx4m to a height of 3 meters Preparation of wooden casts for concrete pouring of the Seprtic Tank roof 5mx5m for each septic tank. Preparation and installation of 5 inches Inlet PVC pipe to the Septic Tank, and a heavy duty Lid-Cover for future emptying purposes. Positioned to the far end of the roof, allowing for later toilets establishmets on top of the Septic tank. "Concrete of both septic tanks roofs must each contain Two Layers of steel reinforcement in 2 Directions, 12mm in Direction X & 12mm in Direction Y. Creating a 20x20cm mesh. Minimum Steel Reinforcement Strength: fy=420MPa" Concrete required (M25) for both septic tanks roof of 20cm Thickness .Minimum Concrete Strength: fc=25MPa, 1-1-2 Mix Ratio (Cement-Sand-Agregate) Establish cinder block Toilets walls on top of one of the previously established Septic Tank to a 3x5m area to a height of 3 meters, with a cinderblock partition in the midle dividing into two toilets (2.5x3m each). Considering installation of one standard PVC door in each toilet. Provision and installation of drainage system and water supply to each toilets components (Sink, Toilet Seat, Floor drainage). Master water supply and drain for each toilet are to be placed at the exterior of the back side of the toilets. Installation of Sandwich pannel roof, which MAG will provide. Provision of Tiles and all needed material, and install them to floors and walls. Provision and installation ofa standart PVC door to each toilet. Provision and installing set of Toilet seat, Sink, floor drainage strainer, and their accessories (Water Mixers, taps, bidet sprayer), and connecting the toilets to the septic tank. ETC Quotation Validity: The cost quoted by the bidder shall be kept firm and unchanged for a minimum of 45 days. When the quotations issued date is not explicit, the deadline of the reception of the bids will be considered. o In case the bidder does not agree with the above. How many days will the quotation be valid? Payment Method: Bidder agrees to follow the MAG standard, bidder agrees to release of 90% of the payment by MAG after 30 days of work completion and 10% Defect liability retention payment by MAG which may be released after 90 days of a satisfactory work/ delivery completion Certificate by MAG. Advance Payment. Bidder agrees with no advance payment as per MAG standards. o Otherwise, the bidder requires an advance payment of % of the total contract The Bidder will not be permitted to take advantage of any errors or omissions in this Invitation to Tender or any Purchase Order or Contract thereafter. Should the Bidder discover any errors or omissions, the Bidder must notify MAG accordingly Tender Link : http://www.iraq-businessnews.com/tenders/