Tenders Are Invited For Modernization Of The Historic Building Of The Primary School. Polish Army In Mrocza

The Subject Of The Order Will Be The Demolition Of The Existing Connector And The Construction Of A New One Located Between The Education Buildings - The Primary School Located At Marszałka Józefa Piłsudskiego Street, Along With The Reconstruction Of Part Of Two Floors Of The Eastern Wing Of The School. The Building Will Include A 3-Story Connector With An Independent Structure. There Will Be A Staircase In The Facility. As Part Of The Works, It Will Be Necessary To Build An External Panoramic Elevator Adapted For Disabled People. Scope Of Planned Works: - Demolition Of The Existing Single-Story Connector Between The Two Schools - Construction Of A New, Independent, 3-Story Building - Connector Between The Schools - Reconstruction Of Part Of The Ground Floor And First Floor Of The Eastern Wing Of The School, Which Is Related To The Communication Connection Of The Designed Elevator With The Existing School. Additionally, On The 1St Floor, There Will Be A Separate Hygiene And Sanitary Facility In The Form Of A Womens And Mens Toilet Adapted For Disabled People. The Connector Building Was Designed As A Building Without A Basement, Covered With A Flat Roof With A Roof Slope Angle Of 2%. Functionally, The Building Will Constitute Vertical Communication With All Floors Of The Existing School From The End Of The 20Th Century / West Wing. Additionally, On The Ground Floor It Will Be Directly Connected To The School From The Early 20Th Century / Eastern Wing And By Designing An External Panoramic Elevator With The Ground Floor And First Floor Of The Above-Mentioned Part Of The School. Floors +1 And +2 Are Planned To Be Suspended Above The Main Entrance To The Connector. The Foundation Of The Building Was Designed As A Direct Foundation On Concrete Footings And Foundation Footings. In Part Of The New Connector, The Above-Ground Walls Are Made Of Silka-Type Lime-Sand Blocks Or Ceramic Hollow Bricks. In The Part Covering The Reconstruction, Partition Walls Separating Hygienic And Sanitary Rooms Should Be Made Using Lightweight Technology - From Plasterboards For The Rooms. Wet, Also With Fire Resistance. The Main Structure Of The Designed Connector Will Be A System Of Columns And Beams. A 20 Cm Thick Reinforced Concrete Slab Is Designed As The Ceiling Above The Ground Floor And The First Floor, According To The Technical Design Of The Structure. An Aluminum Mullion And Beam Façade System With Increased Thermal Insulation And Fire Resistance Of Ei60 Is Designed As A Curtain Wall. The System Is Supplemented With Double-Leaf Emergency Doors With A Passage Width Of The Active Leaf Of Min. 100Cm And Height 220Cm. Glazing With Transparent Glass With Properties That Limit The Transmission Of Sunlight In Order To Maintain Thermal Comfort Inside The Connector. In Addition To Construction Works, The Facility Should Be Equipped With Appropriate Electrical, Telecommunications And Central Heating Installations. , Sewage And Mechanical Ventilation. The Ordering Party Incl