Tenders Are Invited For Delivery And Installation Of A Sewage Compressor Station In Pomiłowo, Commune. Sławno

1. The Subject Of The Order Is The Delivery And Installation Of A Sewage Compressor Station In Pomiłowo, Commune. Sławno In Accordance With The Provisions Of The Construction Law And Implementing Regulations And Obtaining Permission To Use The Completed Sanitary Sewage Networks.2. The Subject Of The Order Specifies: 1) Design Documentation For The Construction Of A Sanitary Sewage System And A Pressure Sewage System With A Sewage Pumping Station In The Town Of Pomiłowo, Commune. Sławno;2) Sketch Of The Sewage Compressor Station. 3. The Scope Of The Order Includes The Delivery And Assembly Of Equipment For The Tank Of The Sewage Compressor Station In Pomiłowo, Sławno Commune. In 2022, A Tank Was Constructed With A Connection To The Gravity And Pressure Sewage Systems. The Following Should Be Made In The Tank: 1) A Concrete Screed At The Bottom Of The Tank (A Pipe For The Pump Should Be Made In The Screed); 2) Compressor Station Equipment, Complete Technology (Compressor Station Tank, Distributor, Retention Tank Of The Compressor Station, Solids Separators, Gate Valves, Ladder, Working Platform, Piping, Pumps, Drainage Pump, Fan); 3) Compressor Station Ventilation, Ventilation Should Be Made Of Acid-Resistant Pipes, Wall Thickness 2 Mm; 4) Control System; 5) Electrical Installation Of The Compressor Station Tank And Installation Of The Control Switchboard Along With The Approach To The Electricity Meter Cabinet. 4. Other Requirements Of The Employer Towards The Contractor As Part Of The Agreed Remuneration: 1) Before Installing The Products, The Contractor Is Obliged To Apply For Product Approval And Obtain Approval From The Investors Supervision For The Material (The Application Template Will Be Developed By The Contractor In Consultation With The Investors Supervision Inspector); 2) Active Capacity Pumping Station Module Must Be Supported By Calculations.3) Indirect Solids Separation System Based On A Horizontal Solids Separator Cooperating With Each Pump.4) The Sewage Pumping Station Module Must Include: A) Elbow Check Ball Valves On The Inlet And Discharge, Minimum Dn80;B) Pn 10 Knife Gate Valves With A Handwheel;C) Pn 10 Knife Gate Valve With A Handwheel On The Inlet;D) Rk Pipe And Flange Connector For Connecting The Gravity Sewer.5) The Pumping Station Tank Must Be Equipped With An Additional Sewage Level Sensor, Which Takes Over The Control Of The Pumps In In The Event Of A Hydrostatic Probe Failure.6) The Pumping Station Must Also Have Large Inspection Rooms, Which Allows For Easy Access For Cleaning Inside And Checking The Technical Condition Of The Retention Chambers And Its Individual Components.7) The Pumping Station Must Have Gate Valves That Cut Off The Inflow Of Sewage To A Particular Part Of The Tank. This Allows For The Following Possibilities: A) Opening The Separator Without The Need To Empty The Retention Tank, B) Cutting Off The Inflow To One Separator And The Pump, Which Allows For Easy Maintenance Work Without Having To Shut