Bids Are Invited For Hiring Of A Legally Established And Specialized Company To Execute Engineering Works For The Construction Of A Basic Health Unit (Bhu), Type I In Masonry, In The Municipality Of São Francisco De Sales, In Compliance With The Ses/Mg Resolution No. 8,753 Of May 16, 2023, According To Technical Engineering Projects That Integrate And Complete This Notice, At The Request Of The Municipal Health Secretariat.

1.1- Executive Project For Concrete Structure (Including Foundation), 1.2- Executive Electrical And Logic Project, 1.3- Executive Project For Hydro Sanitary Facilities, 1.4- Executive Project For Spda, 1.5- Executive Project For Medical Gases, 1.6- Executive Project For Fire Prevention And Fighting, 2.1- Supply And Placement Of Work Sign In Galvanized Sheet #26, Esp. 0.45Mm, Dimension (3X1.5)M, Plotted With Vinyl Adhesive, Affixed With 4.8X40mm Rivets, On 20X20mm Metal Structure, Special. 1.25Mm, Including Support In Autoclaved Eucalyptus Painted With Pva Paint. Two (2) Coats, 2.2- Fixed Protective Siding For Closing Work In Plywood Sheet, Esp. 12Mm, With Module Size Of (110X220)Cm, Including Latex Paint (Pva) With Two (2) Coats, Exclusive Of Gate Opening, 2.3- Land Cleaning, Including Weeding, Raking Up To Twenty (20) Meters Apart And Burning Controlled, 2.4- Temporary Connection With Air Power Input, Cemig Standard, Installed Load From 15. 1Kva To 30Kva, Three-Phase, With Underground Output, Including Pole, Meter Box, Circuit Breaker, Bus Bar, Grounding And Accessories, 2.5- Water Connection Temporary For Site, Including Hydrometer And Easel For Water Measurement - Main Entrance, In Galvanized Steel Dn 20Mm (1/2) - Dealership Standard, 2.6- Work Lease With Template Of Boards Punched Every 2.00M, Reuse (2X ), Including Topographic Team Monitoring To Mark Topographic Point, 2.7- Construction Shed For Deposit And Type-I Tooling, Internal Area 14, 52M2, Made Of Resin Plywood, Including Furniture (Small Work, Effective Up To 30 Men ), Der-Mg Standard, 2.8- Mobilization, Transport Of Personnel And Demobilization Of Work, 3.2- Manual Excavation Of Trench With A Depth Of Less Than Or Equal To 1.5M, 3.3- Manual Backfilling Of Trench, 3.4- Load Of Material Of Any Nature About Truck - Mechanics, 3.5- Transport Of Material Of Any Nature In A Truck 2 Km ≪ Dmt Less Than Or Equal To 5 Km (Within The Urban Perimeter), 3.6.1- Manual Piping At The Bottom Of A Trench With A Socket, Excavation Exclusive, 3.6.2- Lean Concrete, Mix 1:3:6, Prepared On Site With A Concrete Mixer, Without Structural Function, 3.6.3- Forming And Deformation Of Resin Plywood, Reuse (3X) (Foundation), 3.6.4- Cutting, Bending And Assembling Of Ca-50/60 Steel, 3.6.5- Supply Of Structural Concrete, Machined Pumped, With Fck 25 Mpa, Including Laying, Thinning And Finishing, 3.7.1- Forming And Deformation Of Resin Plywood, Reuse (3X), Excluding Shoring, 3.7.2- Cutting, 3.7.3- Supply Of Structural Concrete, 3.7. 4- Pre-Cast Slab, Exposed, Including Capping E = 4 Cm, Sc = 200 Kg/M2, L = 4.00 M, 3.7.5- Structural Concrete Lintel For Spans Above 150 Cm, Control A, With Fck 20 Mpa, Molded In Place, Including Frame, 4.1- Fence Masonry With Perforated Ceramic Brick, Esp. 9Cm, For Cladding, Including Mortar For Laying, 4.2- Fence Masonry With Ecological Brick, Esp. 10Cm, With Apparent Finish, 4.3- Wall In Drywall, Division Between Dry Areas Of The Same Unit (St/St), Esp. 115 Mm, Including Mountings, Guides And Accessories, Exclusive Thermal/Acoustic Insulation, 4.4- Swallow Gray Granite Partition E = 3 Cm, Including Chromed Brass Hardware, 4.5- Perforated Brick Partition Wall E = 10 Cm, Plastered And Latex Painted H = 2.20 M, Including Air Concrete Shoe