Tenders Are Invited For Land Development In Rusinów

3.1. The Subject Of The Order Is The Implementation Of An Investment Task Entitled: Development Of The Area In Rusinowo, In The Scope Of Extending The Development Of The Existing Recreational Area On Part Of Plot No. 128 And 129 Rev. Rusinowo.3.2. The Scope Of The Order Includes: 1) Preparation Of The Investment Area, Including Securing The Construction Site For The Duration Of The Task; 2) Removing Bushes And Performing The Necessary Leveling Of The Area; 3) Communication Routes With An Aggregate Surface, Reinforced With Plastic Edging, With System Fastening, Note: The Gravel Surface (Area 16.81 M²) Should Be Replaced With A Surface Hardened With Crushed Aggregate, Without The Use Of The Designed Steel Resistor At The Junction Of The Surface; 4) Hardening The Area With An Epdm Surface (Color To Be Determined At The Implementation Stage), Supported With The Use Of Rubber Edges 100X25x5cm. Note: The Sandy Surface (Area 65.05 M²) Should Also Be Made As An Epdm Surface5) Hardening The Area With A Polyethylene Grass Surface In The Area Of ​​Outdoor Gyms Note: The Pe Grass Surface For The Ball Game Area (Approx. 20 M²) Should Be Made As A Surface With Natural Grass, Sown On Fertile Soil;6) Elements Of Small Architecture, I.E. Waste Bins, Colorful Roofs, Interactive Whiteboards With A Spiral, Trampoline Zone, Openwork Archway, Gongs And Cymbals, Cuddly Wall, Making A Picnic Set, Exercise Ladders; 7) A Zone For Overcoming Heights With A Built-In Green Hill; Note: The Ordering Party Decides Not To Build A Mole Net. 8) A Climbing Wall Made Of Black Locust Wood With A Polypropylene Climbing Rope Reinforced With Wire, 9) An Outdoor Gym Zone Made Of Relocated Equipment Currently Mounted On The Existing One Playground, 10) A Place For Throwing A Basketball Into A Basket, Together With A Fence On The Side Of The Recreation Area, Should Be Made In The Form Of A Sand Embankment Below The Construction Layers And Compacted To The Is = 0.98 Index. Note: The Installation Of The Ball Catch Posts Should Be Made By Mounting Them On A Square Steel Profile With A Cross-Section Smaller Than The Post, Recessed In Accordance With The Design Documentation, And Exposed At Least 100 Cm Above Ground Level. For The Outer Poles, Braces Made Of A Square Steel Profile With A Length Of Not Less Than 3 M Should Be Provided. The Ball Catch Should Be Made Of Knotless Polypropylene Mesh, Mesh Size 8X8 Cm, Thickness. 5 Mm Mesh, Attached Using A System Solution To Ball Catch Posts And A Coated Steel Cable. 11) Fencing The Area: The Existing Mesh Fence Should Be Dismantled To The Extent Indicated In The Design Documentation, And A Panel Fence With A Total Length Of Approx. 60 M And A Coated Mesh Fence With A Length Of Approx. 85 M Should Be Constructed. 12) Planting In Accordance With The Indication Of The Field Scope In The Greenery Technical Design Documentation, For The Species And Their Quantities As Follows: A) Fortunes Bumblebee Emerald Gaiety - 275 Pcs. B) Fortunes Bumblebee Minimus - 275 Pcs. C) Japanese Groundwort – 365 Pcs. D) Forsythia Intermedia – 6 Pcs. E) White Dogwood – 4 Pcs. . I) Callifolia Physalis Diabolo - 4 Pcs. J) Dammers Cotoneaster - 90 Pcs. K) Hedge Plants: Callifolia Physalis Little Angel - 60 Pcs. Japanese Meadowsweet Goldmound - 35 Pcs. Compressa Dogwood - 50 Pcs. Palm Maple - 1 Pc. The Ordering Party Decides Not To Plant Common Hornbeam And Arborvitae And This Should Not Be Included In His Offer. 3.3. The Colors Of Small Architecture Elements, Elements Of The Outdoor Gym And Epdm Surfaces Should Be Agreed With The Ordering Party At The Stage Of Investment Implementation. 3.4. The Thuja Plantings Located Next To The Fence To Be Dismantled, Approximately 10 Pieces, Should Be Transplanted To The Location Agreed With The Ordering Party At The Implementation Stage, On Plot No. 129. 3.5. The Sandbox And Swing Located In The Playground Should Be Dismantled And Reinstalled In The Place Indicated At The Stage Of Works On Plot No. 129, In The Same Way As Elements Of Outdoor Gyms. 3.6. The Ordering Party Resigns From Implementing The Sensory Path. In Its Place, Topsoil Should Be Applied And The Area Should Be Sown With Grass. 3.7. The Order Includes 5 Bicycle Racks, Approximately 75 Cm High And 85 Cm Wide, Powder-Coated In Ral 7016.3.8. Waste Bins In The Number And Location In Accordance With The Design Documentation, With A Capacity Of Not Less Than 45 Liters, Steel Frame Structure, Powder-Coated Black, Finished With Impregnated Wood Boards, In Accordance With The Illustrative Photo Attached Above. 3.9. The Scope Of Design Documentation Excludes Works Related To The Renovation Of The Observation Tower. 3/10 It Is Recommended That The Contractor Make A Local Visit To The Site Of Construction Works In Order To Obtain Information Necessary To Prepare The Offer, Conclude The Contract And Execute The Order. Particular Attention Should Be Paid To The Route Of Transport Of Construction Materials With Heavy Equipment, And Any Damage To The Surface Caused During Construction Works Should Be Planned For Reconstruction. 3/11. The Subject Of The Order Was Specified In The Design Documentation, Which Is The Basis For Determining The Price, Including: 1) Land Development Project For The Investment Entitled: Development Of A Recreational Area In The Town Of Rusinowo As Part Of Non-Intrusive Social Services On Plots No. 128 And 129 In The Area. Possibly Rusinowo, 2) Architectural And Construction Design For The Investment Titled: Development Of A Recreational Area In The Town Of Rusinowo As Part Of Non-Intrusive Social Services On Plot No. 128 And 129 In The Area Possibly Rusinowo, 3) Technical Design For The Investment Entitled: Development Of The Recreational Area In Rusinowo As Part Of Non-Intrusive Social Services On Plot No. 128 And 129 In The Area Or Rusinowo,4) Technical Specifications For The Execution And Acceptance Of Construction Works For The Investment Entitled: Development Of The Recreational Area In Rusinowo As Part Of Non-Intrusive Social Services On Plots No. 128 And 129 In The Area Or Rusinowo”,5) Bill Of Quantities. 3/12. The Components Of The Subject Of The Contract Also Include All Works And Services Accompanying The Implementation Of The Works Referred To In The Description Of The Subject Of The Contract, In Particular: Costs Of Preparing As-Built Documentation Necessary To Apply For An Occupancy Permit, Costs Of Surveying Services, Costs Of Obtaining The Necessary Tests, Incl. Including: Costs Of Conducting Emergency Archaeological Research, Implementation Of Fire Safety Instructions And Marking, If Necessary, Research And Inspection Protocols, Costs Of: Water And Electricity Consumption, Construction Insurance, All Preparatory And Cleaning Works, Construction Site Security, Maintenance Of Construction Facilities And All Costs Of Removal/Transport Of Materials From Demolition, Excavations And Waste Disposal. The Price Must Also Include The Costs Of As-Built Surveying Documentation And Vat.3.13 All Works Must Be Carried Out In Accordance With The Applicable Construction Regulations, Standards And Established In This Specification. Conditions.3.14. The Contractor Is Obliged To Use Materials Approved For Trading And Use In Construction In Accordance With The Declaration Of Performance And Technical Criteria Specified In The Product Standard And Technical Approvals. After Completion Of Construction, Certificates And Quality Certificates, Attestations Or Equivalent For Built-In Building Materials Must Be Presented.3.15. Before Signing The Contract, The Contractor Is Obliged To Submit Offer Cost Estimates To The Ordering Party.3.16. Please Note That In The Case Of A Lump Sum Remuneration, The Bill Of Quantities Is Not The Basis For Determining The Scope Of Construction Works Covered By The Subject Of The Contract. The Items Included In The Bill Of Quantities Are Only Intended To Be An Aid In Calculating Investment Costs, Therefore It Is Only A Document Supporting The Valuation Of The Project.3.17. If The Description Of The Subject Of The Contract Indicates Trademarks, Patents Or The Origin, Source Or Specific Process That Characterizes The Products Or Services Provided By A Specific Contractor, Such Indication Shall Be Accompanied By The Words Or Equivalent.3.18. The Ordering Party Allows Equivalent Solutions, Not Worse Than Those Mentioned In The Description Of The Subject Of The Order. Any Indication Of Trademarks, Patents Or Origin, Source Or Specific Process In The Description Of The Subject Of The Order Is Only Intended To Specify The Quality And Technological Expectations Of The Ordering Party. The Ordering Party Allows Equivalent Solutions With The Same Technological, Performance And Functional Level In Accordance With The Assumed Description Of The Subject Of The Order. All Possible Own Names And Trade Brands Of Building Elements, Systems Included In The Swz And Design Documentation Were Used To Specify The Quality And Technological Expectations Of The Ordering Party.3.19. Pursuant To Art. 101 Section 4 Of The Public Procurement Law, The Ordering Party Allows Solutions Equivalent To Those Described In Standards, Technical Assessments, Technical Specifications And Technical Reference Systems Referred To In Art. 101 Section 1 Point 2 And Section 3 Of The Act Pzp.3.20. Cpv Code: 45111291-4 Land Development Works.