Tenders Are Invited For Reconstruction And Change Of Use Of The Hall Into Office Space On The Ground Floor Of The Existing District Office Building.

As Part Of The Task, The Contractor Is Obliged To Perform The Following Works:1. Demolition Of The Partition Wall.2. Demolition Of A Diagonal, 12 Cm Thick Brick Wall. It Will Not Have A Negative Impact On The Structure, It Will Relieve It Locally.3. Carving Three Holes In The Brick Walls.4. Forging Door Openings In Three 25 Cm Thick Load-Bearing Walls. Forging According To The Structure Design.5. Dismantling Glass And Aluminum Walls.6. Dismantling Three Aluminum And Glass Walls With Entrance Doors - Separating Three Office Rooms.7. Dismantling The Pole Casing.8. The Two Existing Hall Columns Are Covered With Silver Aluminum Sheet Covers. It Is Planned To Dismantle The Housings.9. Dismantling The Suspended Ceiling. 10. Dismantling The Suspended Ceiling In The Existing Hall And Three Existing Offices (Within The Scope Of The Designed Office Rooms). The Designed Rooms Will Remain Without A Suspended Ceiling In Order To Obtain A Room Height Of Min. 3.0 M As In The Adjacent Existing Office Rooms..11. Material And Finishing Solutions.12. Floors. Existing Ceramic Tile Floors Will Be Destroyed After Dismantling The Existing Walls. It Is Planned To Lay New Ceramic Tile Floors Similar To Those Existing In The Adjacent Office Rooms. Tiles Must Be Intended For Public Buildings With Increased Abrasion Resistance And Anti-Slip Properties. Existing Tiles Are Allowed As Long As They Are Left Undamaged.13. Door Joinery. Door Dw1 – With Passage Dimensions (In The Frame Space) Min. 90X200cm - Board, Veneered, Wood Color - Pattern And Color As Existing For Adjacent Rooms. Door Dw2 - Gray Glass And Aluminum Walls - As Existing. Safety Glass. Doors With Passage Dimensions (In The Frame Space) Min. 90X200cm Glass And Brick Walls Should Be Made As Ei30.14. Plastering, Painting And Wall Coverings. Walls – Gypsum Plasters. Smooth With Putty And Prime. Paint With White And Beige Latex Paint. Paint The Side Of The Corridor In The Color Of The Existing Walls.15. Ceilings: After Dismantling Ceilings, Check The Load-Bearing Capacity Of The Existing Plaster. If Necessary, Chip Off The Existing Plaster And Apply New Plaster. Smooth With Putty And Prime. Paint With White Acrylic Paint.16. Ventilation. There Is No Ventilation In The Existing Rooms. Two Channels Are Planned: O 100 (Main) And O 80 (Side To Adjacent Rooms). Channels Made Of Sheet Metal Covered With 3 Cm Of Mineral Wool And Covered With Plasterboards. Finally, Install Anemostats: In The Room. 0.2 – V20, Indoors 0.3 – V20, Indoors 0.4 – V80. Install The Dalap 100 Ap Quiet Axial Duct Fan On The O 100 Duct. Enclose The Fan With Plasterboards. Use An Inspection Opening With A Door For Easy Disassembly In The Event Of A Breakdown.