Tenders Are Invited For Delivery Of The Assortment Needed For Electrosurgical Procedures And Others (Diathermy)

Electrosurgical Device, Mono-Polar, With A Coated Knife Electrode, Three Buttons - Cutting, Coagulation And A Mode Enabling Simultaneous Cutting And Coagulation While Maintaining Minimal Thermal Spread, Power Regulation From The Handle In The Sterile Field, And A 3 M Or 4.6 M Cable. Monopolar Handle With Coated Knife Electrode With Single-Use Push-Button Or Rocker Switch, Coated Electrode, With Hexagonal Lock And 3 M Cable. Patient Neutral Electrode For Adults, With A Real-Time Monitoring System And A Gel That Cools The Skin In The Place Where The Electrode Is Attached. With Cable. Elongated, Sterile, Single-Use Monopolar Electrodes With A Coated Blade, Intended For Surgical Procedures, Compatible With The Valleylab Ft10 Diathermy Device Owned By The Ordering Party. Total Length: 16.51 Cm (6.5 Inch), Working Length: 2.54 Cm (1 Inch). Op. A 50 Pcs. Elongated Monopolar Electrodes, With A Coated Blade. Total Length: 10.16 Cm (4 Inch). Working Length: 2.54 Cm (1 Inch), Pack. 50 Pcs. Electrosurgical Knife With Push-Button Switch, Single-Use, Sterile. The Electrode Has A Stainless Steel Blade, Supplied With A Holster. 3 M Cable. 3-Pin Connector, Compatible With The Valleylab Ft10 Generator, Pack 50 Pcs. Electrodes For Monopolar Holder With Coated Blade, Single Use. Hexagonal Latch. Total Length: 6.35 Cm (2.5 Inch). Working Length: 2.8 Cm (1.1 Inch), Pack 50 Pcs. Stainless Steel Ball Electrode. Total Length: 5.1 Cm (2 Inches). Working Length: 5.6 Mm (0.22 Inch). Diameter: 5.6 Mm (7/32 Inch). Tungsten Electrode With Wire Loop. Total Length 5 Cm (2 Inches). Working Length: 0.95 Cm (0.38 Inch). Diameter 9.5 Mm (3/8 Inch). Flat Hook Laparoscopic Electrode With An L-Shaped Tip, Made Of Thin Or Thicker Wire Covered With A Layer Of Material With Elastomeric Properties That Minimizes Electrode Contamination With Coagulated Tissue, Minimum Length 35 Cm, Compatible With The Valleylab Ft10 Generator , Op. 10Pcs Tungsten Loop 20Mm X 12Mm Shaft Length: 13Cm (5In)