Tenders Are Invited For Engineering Design Services For The Construction Of Civil Engineering Works – New Building/Expansion To The 8-Train Igs Lindenau, Planning Service According To § 55 Hoai Technical Equipment (Hls), Service Phases 2-9

Engineering Design Services For The Construction Of Civil Engineering Works – New Building/Expansion To The 8-Train Igs Lindenau, Planning Service According To § 55 Hoai Technical Equipment (Hls), Service Phases 2-9. According To The School Development Plan, The City Of Hanau Is Planning To Expand The Lindenau Integrative Comprehensive School Into An 8-Grade Igs With A 4-Grade Upper School In The Großauheim District Of Hanau. The New Building Serves To Accommodate The Space Required As Part Of The Expansion. In A Separate, Subsequent Project It Is Planned To Adapt The Existing Buildings To Requirements. The School Is Housed In 5 Building Parts With A Floor Area Of ​​Approx. 14,800 M² On The School Property, Which Covers A Total Area Of ​​Over 22,100 M². A Container Facility With 4 Differentiation Rooms Has Already Been Built For Temporary Use In The Rear Schoolyard. On The Ascheplatz Adjacent To The Southeast, An Area Of ​​Approximately 5,200M² Is Earmarked For The New Extension. A 3-Story Building With A Gross Floor Area Of ​​Approx. 3,980M² Is Planned. The Supporting Structure Should Be Of Solid Construction. The Facade As A Wooden Frame Construction Made Of Prefabricated Modules. Planning For The Construction Project Will Take Place In 2024. Construction Will Begin In Mid-2025 And Completion Is Planned For Mid-2027. The Hls Planning Services Include: - Drinking Water Supply: Design As A Cold Water System, Ensuring Drinking Water Hygiene Using Flushing Devices. Hot Water (E.G. Medical Room/Kitchen) Decentrally Using Instantaneous Water Heaters Or Fresh Water Stations. - Drainage: Drainage Pipes Inside And Outside The Building. Connection To New Sewer Connection. The Rainwater Should Be Drained Via An Underground Trench. - Sanitary Objects: Toilet With Flush Plates And Urinal Systems As Well As Hand Basins With Sensor-Controlled Fittings. - Heating: The Transmission Heat Requirement Should Be Covered Via Static Heating Surfaces. The Heat Should Be Supplied Via A District Heating Transfer Station. Alternative Energy Concepts Are Desired. - Ventilation: The Classrooms And Lounges As Well As The Cafeteria And Kitchen Area Should Be Mechanically Ventilated And Ventilated. If Possible, The Ventilation Unit Should Be Located In The Attic/Roof Area Of ​​The Building. Necessary Zoning Should Be Planned. Interior Rooms And Toilet Rooms Should Be Equipped With Energy-Efficient Individual Room Fans. Alternative Ventilation Concepts Can Be Suggested - Msr Technology: The Planning Of Building Automation Should Only Be Planned Using Decentralized Control Technology. Simple “Stand-Alone” Room Thermostats Will Be Used For The Project. A Classic Field Level Setup; Automation Level And Management Level Is Not Part Of The Ga Planning In This Project. There Are Therefore Only Minimal Requirements For Ga Planning, Since The Intended Controls Can Already Fulfill Their Control Tasks At The Field Level And Are Parameterized And Adjusted In The Basic Programs Already Provided By The Manufacturer Of The Room Thermostats. In Order To Be Able To Optionally Retrofit A Glt Later, An Open One Should Be Installed