Tenders Are Invited For V 00761 - Autoclave Delivery

The Subject Of The Performance Of This Contract Is The Delivery Of An Autoclave, I.E. The Performance Of The Expected Within The Planned Subsidy Project Entitled New Robust Erp And Production Technology For Falco Sokol A.S.. The Technical Parameters Are As Follows, With The Fact That The Client Allows Their Modification While Maintaining The Principle That Performance And Range Parameters Are Set As Minimum And Power, Size And Weight Parameters As Maximum, Unless Something Else Is Stated For A Specific Parameter, With A Tolerance So That The Device Could Be Installed In The Location Designated For This Device. This Contract Includes Assembly, Commissioning At The Place Designated By The Client. The Selected Supplier Is Responsible For Ensuring That The Order Will Be Delivered Complete And Will Contain All The Parts Required For Flawless Operation. Only Original (Not Refurbished) Components Will Be Used For Production. The Technical Specification Sets The Basis For The Minimum Requirements For Function, Performance, Service Life, Etc. If The Zd Or Its Annexes Contain Specific Trade Names Or Brands, This Is Only A Definition Of The Required Standard, And The Contracting Authority Allows For Other Technically And Qualitatively Comparable Solutions. Required Working Dimensions Of The Autoclave: Min 1400 X 6000 Mm, Minimum Capacity 6 Baskets At The Same Time Required Size And Number Of Baskets, Chassis And Inserts: Basket Min Dimensions L: 950 Mm W: 920 Mm H: 920 Mm - Number: 16 Chassis: Min Dimensions L: 990 Mm W: 730 Mm Track Spacing: 600 Mm – Number: 16 Interlock: Min Dimensions L: 885 Mm W: 915 Mm Thickness: 3 Mm – Quantity: 200 Sterilization Process Specifications: A) Steam Cycle With Forced Circulation By Fan B) Shower Cycle With Steam Injection Heating In The Autoclave C) Shower Cooling Through A Tubular Heat Exchanger D) Overpressure With Compressed Air During The Entire Cycle (4 Bar) Required Accessories: A) Loading/Unloading Chain With A Drive Attached To The Rear Of The Autoclave By A Flange B) Laboratory Sensor Set F0 I. Special Measuring Technology, With The Help Of Which It Is Possible To Monitor The Temperature In The Core Of The Product In Real Time. And The Autoclave Automatically Calculates The Efficiency Of The Sterilization Effect And Calculates The F0 Value Itself. C) A Control System That Meets The Requirements Of The Subsidy Title Industry 4.0. I. This Means That The Autoclave Will Be Ready To Receive Tpv Online From The In-House System Based On A Standardized Data Interface. Based On This, The Autoclave Automatically Starts The Sterilization Process, Ends The Program Itself After The End Of The Sterilization Process And Transmits The Information To The In-House System. The Autoclave Must Be Able To Use Its Sensors To Detect Errors Such As Too High/Low Temperature, Too High/Low Pressure, Low Water Level And Any Other Serious Process Errors. Based On The Detection Of These Errors, The Autoclave Must Be Able To Automatically Adjust The Length And Parameters Of The Sterilization Process Or Stop The Process Completely. All These States Are Recorded And Reports About Them, Together With Other Data, Must Be Transferred To The Internal Company System. Ii. The Plc Must Also Function As A Paperless Digital Recorder. All Process Data Will Be Recorded In Non-Volatile Memory In A Tamper-Resistant Format As Required By Us Fda 21 Cfr 113.100 For Electronic Record Keeping. D) Software Suite I. A Software Package That Will Allow Displaying, Printing And Evaluating Individual Sterilization Cycles. But At The Same Time, So That They Are Automatically Downloaded Directly To The Selected Folder On The Remote Ftp Server.