Barrel Cone Barrel Type Cone For Traffic Signaling, Super Cone Barrel, Cylindrical, Made Of Low Density Polyethylene, With Uv Ray Protection, Weather Resistant, (Sun And Rain), 1.23 M High, With 03( Three) High Visibility Reflective Adhesive Tapes, 07 (Seven) Cm Each, With Individual Recess For Their Protection. In The Upper Part, It Has A Handle For Easy Transport And A Hole For Fitting An External Or Internal Warning Light (Night Signal). Square Base, 60 Cm X 60 Cm, With External Area For Personalization. On Each Piece, The Logo Of The Department Of Transit, Transport And Mobility Must Be Printed Or Silk-Screened, And The Inscription A Quente Of The Word Transito Must Also Be Engraved On Its Base, As Per The Annex. There Must Be An Internal Area To Accommodate Sand Drawers (Included). In The Lower Part, It Has 04 (Four) Elevations For Water Passage. Cone Weight 5.0 Kg, And With The Sand Drawers Attached, It Reaches Up To 12 Kg. Stackable For Easy Storage. ..., Plastic Barrier (Or New Jersey Barrier), As Description Attached., Detachable Easels Detachable Easels For Traffic Signaling Plastic Easel Type, Detachable, Made Of Polyethylene, Low Density, Weather Resistant (Sun And Rain), With Approximate Dimensions Of 01 (One) Meter In Height By 02 (Two) Meters In Length And 90 (Ninety) Cm In Width In Orange Color, Have 02 (Two) Beams Of 02 (Two) Meters In Length By 17 (Seventeen) Centimeters In Width, With High Visibility Reflective Sticker, And Recess For Their Protection, On Both Sides Of The Piece. It Has A Top Hole To Fit An External Warning Light (Night Light). With Mineral Filling (Sand) On The Sides, Weighing Approximately 8.5 Kg To 27 Kg. Each Piece Must Have The Logo Of The Traffic Department Printed Or Silk-Screened, As Per The Annex. ..., Type 2 Delimiter Cylinder, Polyester Resin-Based Glue, Accompanied By Catalystnote: Specifications Attached, 08/30/2023, Cones (Flexible) For Signaling (Rubberized Type)Cones For Traffic Signaling, Consisting Of A Single Piece Without Splices And Without Attachable Ballast, They Must Be Made Of Synthetic Composite Material And With Flexible Characteristics, Being Unbreakable And Resistant To Weathering. They Must Have A Finish That Is Free Of Surface Defects, Burrs Or Sharp Edges And Cannot Cause Damage To Vehicles When Collided Or Suffer Permanent Deformations. Be Predominantly Orange, With 2 (Two) Reflective White And Self-Adhesive Strips Of 10 Cm Wide Each, According To The Standard Established In The Abnt Nbr 15071/2015 Standard, The Films Must Have Adequate Adhesion To The Application Substrate, So As To Ensure Adherence To The Daytime, Nighttime Use In Places Of Low Visibility, Such As: Tunnels, Foggy Areas, Etc. They Must Meet The Minimum Retroreflection Requirements Set Forth In Abnt Nbr 16644/2013, For Films Of At Least Type Iii (Vertical Road Signaling - Film Requirements). They Must Be White, Self-Adhesive And Sufficiently Flexible, So That They Do Not Present Cracks Or Breaks. Its Mass Should Be Between 3 Kg And 4 Kg, Its Height Should Be Between 85 Cm And 95 Cm And With A Base Width Of Approximately 40 Cm. The Logo Of The Department Of Transit, Transport And Mobility Must Be Printed Or Silk-Screened On Each Piece, And It Must Also Be Engraved On Its Base.
