Tenders Are Invited For Partial Repairs Of The Surface Of Municipal Roads In The Kruszwica Commune

Common Procurement Vocabulary: Cpv 45230000-8 Construction Works For The Construction Of Pipelines, Communication And Power Lines, Highways, Roads, Airports And Railways; Leveling The Land Ordering Party: Kruszwica Commune Completion Date: Up To 8 Weeks From The Date Of Concluding The Contract1. Subject Of The Contract: The Subject Of The Contract Is The Performance Of Partial Repairs Of Municipal Roads Located In The Kruszwica Commune With A Bituminous Surface And Made By The Method Of Surface Consolidation With Asphalt Emulsion And Grits. The Order For The Repair Of Municipal Roads Made With The Method Of Surface Consolidation With Asphalt Emulsion And Grits Includes: • Filling With Asphalt Emulsion And Grits Of Cavities Up To 2 Cm Deep Using A Repairer • Filling Cavities With Asphalt Emulsion And Grits Up To 4 Cm Deep Using A Repairer • Liquidation Of Cracks And Crevices With Asphalt Emulsion And Grit Using A Repairer The Scope Of Works Related To Filling The Gap, Pothole, Broken Edges, And Removing Cracks And Crevices With Grits And Asphalt Emulsion Using A Repairer Includes: • Preparation Of The Damaged Place For Repair • Covering The Cleaned Place With The Spray Method Using Asphalt Emulsion The Task Of Which Will Be To Bind The Substrate And The Edge Of The Repaired Pavement Defect With The Filling• Pressure Filling Of The Defect With 5/8 Mm Or 2/5 Mm Grit (Depending On The Depth Of The Defect) Surrounded By Asphalt Emulsion• Filling The Remaining Part Of The Defect Under Pressure With 2/5 Mm Fraction Grit (In Prov If Used For The Bottom Layer Of Grit 5/8 Mm) Surrounded By Asphalt Emulsion • Sprinkle The Surface Of The Renovated Place With Dry Grit 2/5 Mm Without Binder • Clean Up The Place After The Renovation • Remove The Safety Devices And Vertical Markings And Make The Place Of The Repaired Section Accessible To Traffic The Employer Does Not Allow Repairs With The Use Of A Sprinkler And Manual Spreading Of Grits. The Order For Repairs Of Municipal Roads With A Bituminous Surface With A Hot Mineral-Bitumen Mixture Includes: • Incorporation Of Mmb In The Amount Of 150 Mg In Hot Form. Includes: • Preparation Of The Damaged Site For Repairs • Cutting Out The Damaged Areas Of The Surface, Giving Them Regular Shapes • Cleaning The Damaged Areas With The Removal And Disposal Of The Excavated Material • Supplementing The Foundation With Mechanically Stabilized Broken Aggregate 0/31.5Mm To The Bottom Height On The Bituminous Surface • Sprinkling The Repaired Place With C60b3zm Asphalt Emulsion In The Amount Of 0.5 Kg/M2. • Spreading Mineral-Bitumen Mixture With A Grain Size Of 0/8 Mm (Ac8 S 50/70) And 0/11 Mm (Ac11 S 50/70) For Kr 2, Laid Manually Or Mechanically Using Pavers And Steel Rollers Or Compactors In One Or In Two Layers, Depending On The Depth Of Damage• Compaction Of Individual Layers Of The Mixed Mixture• Clearing The Place After The Repair Performed• Removal Of Safety Devices And Vertical Markings And Making The Site Of The Repaired Section Accessible To Trafficorder For Repairs Of Municipal Roads With A Bituminous Surface With A Hot Mineral-Bitumen Mixture - Overlay In Wróble (According To The Bill Of Quantities) Includes: • Execution Of Cold Milling Of Bituminous Surfaces On The Thickness Of Up To 4 Cm • Cleaning And Sprinkling Of Construction Layers - Bituminous Layers • Performing Partial Repairs Of Bituminous Asphalt Surfaces With Mineral-Asphalt Mixtures, With Cutting The Damage Edge Manually On The Main Course • Execution Of The Wearing Course Of Asphalt Concrete Ac 11 S, Gr. 4 Cm • Clearing The Place After The Repair • Removing The Safety Devices And Vertical Markings And Making The Place Of The Repaired Section Available For Traffic Signing The Contract. B) Acceptance Of The Works Must Be Made By The Representative Of The Employer And The Contractor In A Protocol. Quantities: • Partial Repair With Asphalt Emulsion And Grits Using A Repairer, Without Cutting The Edges, With An Average Depth Of 2 Cm: 1000 M² • Partial Repair With Asphalt Emulsion And Grits With A Repairer, Without Cutting The Edges, With An Average Depth Of 4 Cm: 1000 M² • Partial Repair With Asphalt Emulsion And Gr Ysy Roads With A Repairer, Without Cutting The Edges - Ravine: 450 M² • Partial Repairs Of Bituminous Pavements With Mineral-Bituminous Mixtures, With Cutting The Damage Edges Manually: 150Mge) The Contractor Is Obliged To Have Appropriate Technical Equipment. The Equipment Listed Below Must Be In Full Working Order, Ready To Be Presented To The Tender Committee: • Saw For Cutting Asphalt - 1 Pc. • Pneumatic Hammer - 1 Pc. • Compressor (Blower) For Removing Impurities And Dust - 1 Pc. • Heater For Drying And Surface Heating - 1 Pc. • Plate Compactor Or Roller - 1 Pc. • Emulsion Sprayer - 1 Pc. • Car With Double-Walled Thermos Flask And Heating System - 2 Pcs. • Tipper Truck 5T - 1 Pc. • Specialist Road Repairer - 1 Pc. • Bitumen Paver Equipped With An Electronic Controller And Vibrating Board Or Equivalent Equipment - 1 Pc. • Mechanical Brush - 1 Pc. • Self-Propelled Binder Sprayer Equipped With A Measuring Device And An Adjustment Mechanism That Ensures Even Distribution Of The Binder In The Longitudinal And Transverse Direction -1 Pc. • Planer - 1 Pc. • Static Roller - 1 Pc. 2. Requirements Of The Employer In Connection With Art. 95 Of The Public Procurement Law: The Employer Requires The Contractor Or Subcontractor To Employ Persons Performing All Activities Included In The So-Called Direct Costs Based On An Employment Contract. This Requirement Applies To Persons Who Perform Activities Directly Related To Construction Works In The Scope Of Performance Of The Subject Of The Contract In The Number Of People Necessary To Perform The Subject Of The Contract, Including: Construction Worker - Road Works, If The Performance Of These Activities Consists In Performing Work Within The Meaning Of The Provisions Of The Labor Code, Unless These Activities Will Be Performed By A Person As Part Of Their Business Activity. Detailed Requirements In Connection With Art. 95 Of The Public Procurement Law Were Included In §19 Of The Contract Template.