Tenders are invited for Restoration Of The Former Parish Building As Well.

Restoration Of The Former Parish Building As Well. For The Renovation Of The Planned Building, Szabás, Fő U. It Takes Place On The Property Under 49. (175/2 Hrs.). Regarding Its Function, The Former Reformed Parish Building Is Being Renovated, Its New Function Will Be A Community Building. The Building Is Under Monument Protection. The Building Has A Basement (20.18 M2) + Ground Floor (78.69 M2) + First Floor (81.37 M2), Rectangular Floor Plan, 10.45M X 11.45M. The Useful (Net) Floor Area Of ​​The Building Is 180.24 M2. The Attic Will Not Be Installed. The Building Has Drinking Water And Electricity. The Building Is Partially Accessible By Making The Entrance, Parking Lot And Pedestrians Accessible. The Power Supply Will Be Provided By A Solar System, The Heating Is Fully Electric. Wastewater Treatment Takes Place Within The Plot. In The Building, 5 Rooms, 1 Water Block (Toilet), Kitchen, Storage And Mechanical Room Were Planned, With The Necessary Corridor And Passage, With The Renovation Of The Basement As Storage. Load- Bearing Structures Regarding The Condition Of The Load-Bearing Structures And The Planned Interventions, See The Wood Protection And Support Structure Expert Opinions, As Well As The Static Working Parts! The Expert Recommendations Of The Value Inventory Contain Detailed Instructions For Each Element To Comply With The Monument Requirements . Foundation Interventions Related To The Foundation Are Not Necessary. Load Bearing Walls Large, Compact, Burnt Clay Brick Structures With Lime Mortar Binder. The Cracks That Have Formed Are To Be Repaired By Wall Stitching. Space Coverings With Vaults There Is No Need To Strengthen The Vaults, Local Interventions Are Required, With Wall Stitching Of The Cracks That Have Formed. Wood Floors Retaining The Exposed Beamed Wooden Floors Is Important From The Point Of View Of Historic Preservation, Heritage Protection Regulations And The Preservation Of The Originality Of The Interior Spaces. The Size Of The Beams Is Suitable For Carrying Loads, But Their Shape Changes Are Significant. The Decking Practically Needs To Be Completely Replaced. Stairs The Basement Stairs Are To Be Renovated By Repairing, Aligning And Replacing The Existing Edged Brick Steps. The Attic Staircase Is To Be Remanufactured According To The Existing Model. This Can Be Clarified During A Design Tour. Floor Structure The Coordination Of Element Replacements And Relocations Of The Wooden Floor And The Roof Chair Must Be Finalized During The Design Supervision. Non-Load-Bearing Structures Roofing As A New Roofing, A Double Burnt Clay Tile Covering Is Made, With Brick Elements, In A Natural Red Color, With Mortared Relief Next To The Gable Edges, Cone Tiles And Chimneys. Tin Structures In Order To Protect The Building, The Gutter Along The Eastern And Western Eaves Is Being Made. The Roof Section Below The Gutter Is Covered With Corrugated Tin. The Two Attic Vents On The Roof Are To Be Rebuilt. External Plasters, Painting During The Renovation, The Baggy, Eroded And Mossy Layers Must Be Removed. On The Upper Surfaces, Re-Plaster With Traditional, Cement-Free Lime Mortar Plaster And The Original Plaster Banding. It Is Necessary To Apply Salt-Binding, Breathable Plaster On The Plinth And Up To The Height Of The Parapets. Interior Plasters And Paints From A Technological Point Of View, The Guidelines Are The Same As Those Described For External Plasters, But With Lime Painting. Floor Structures Historical Floor Coverings, Including Their Materials, Represent Historical Value, Which Should Be Preserved, Renovated And Rebuilt. Waterproofing Active Waterproofing Is Not Produced. It Has A Large Air Pore Content To Reduce Absorbed Wall Dampness Dry Floor Layering, Gravel Bed On The Outside, Salt-Binding, Breathable Plaster Is Made On The Lower Zone Of The Walls. Thermal Insulation Rock Or Glass Wool Insulation On The Upper Surface Of The Floor Closing Slab. It Is Not Made In Other Places. Door Latches The Interior Doors Of The Building Have Been Preserved In Their Original Condition. We Are Planning To Refurbish Them, With The Necessary Element And Hardware Replacement, Repair, And Fitting. The Exteriors As Well As The Missing Slats Must Be Remanufactured. Internal Partitions After The Floor And Wall Coverings Have Been Completed, The Space Separation In The Newly Designed Wc Group Will Be Divided With A Contemporary-Looking, Solid Construction Board Partition Wall System Mounted On A Metal Frame. Pavement Around The Building And Sewage Drainage A Geotextile Above The Single-Grain Gravel Ventilation Layer Described For The Floor Coverings, And An Outward-Sloping Traffic And Structure-Protecting Flagstone Pavement Above The Sand Bed Will Be Constructed . Replacement (Iron Plates, Doors , Etc.). It Is Not Necessary To Ensure Its Usability. Fireplace Doors One Iron Door Is Made In The Ground Floor Corridor And Two In The Upper Floor, Using The Remaining Hardware . Utilities The Property Is Currently Supplied With Drinking Water And Electricity, But Only Up To The Connection Point Of The Utilities, The Building Itself Is Unsupplied. Civil Mechanical Engineering According To Professional Plans. Building Electricity According To Department Plans. 45000000-7 The Detailed Technical Description Is Contained In Other Public Procurement Documents.