Tenders are invited for Rheometer

Rheometer Item Quantity Description Unit Price Total Price 1 1 Rheometer Description/Purpose (Include How It Aligns To The Approved Plan Of Work): This Equipment Is Essential For Our Continuing Research In Coated Ham Nets And Food Industry Collaborative Projects (Sausages, Sauces, Etc.). This Equipment Is Highly Beneficial To Conduct Mechanical And Thermal Stability Of Liquid And/Or Paste, Texture, Viscosity, Flow, And Other Rheological Behavior Of Food Products. It Is Highly Beneficial To Provide More Specific And Accurate Data, Which Are Fundamental For Decision-Making In Both Research And Industries. Specifications: • Air, Fine-Pored Carbon For The Bearing Design • Electronically Commutated (Ec) – Permeant Magnet Synchronous Motor For The Motor Design • High-Resolution Optical Encoder For The Displacement Transducer Design • Requires Active Thermal Management Of Bearing And Normal Force Sensor • Required Torque (Rotation) ≥ 100N Nm. • Required Torque (Oscillation) ≥ 50 Nnm • Required Maximum Torque ≥ 300 Nnm • Required Minimum Angular Deflection (Set Value) ≤ 0.05 Μrad 3 • Required Maximum Angular Deflection (Set Value) = ∞ Μrad • Required Minimum Angular Velocity = 0 Rad/S • Required Maximum Angular Velocity = 220 Rad/S • Required Maximum Speed = 2100 1/Min • Required Minimum Angular Frequency ≤ 10−7 Rad/S • Required Maximum Angular Frequency = 628 Rad/S • Required Maximum Frequency = 100 Hz • Required Normal Force Range = -70 To 70 N • Required Temperature Range = -160°C To 1000°C • Required Maximum Pressure Range = 1000 Bar • Required Features: O Device Display With Remote Control Of Software (Decoupled From Measuring Sensor For Mechanical And Electromagnetic Interference Prevention) O Direct Strain/Stress Controller O Sample Adaptive Controller (An Auto-Tuning, Adaptive Controller Used In Rotational And Oscillatory Measurements With Controlled Shear Rate Or Controlled Strain Which Automatically Adjusts Controller Parameters For Highest Performance Based Upon The Sample Properties) O Raw Data (Laos, Waveform) O Normal Force Profiles (Set And Read) O Velocity Profiles, Tack, Squeeze O Automatic Gap Control/Setting (Agc/Ags) O Electronic Trim Lock For Measuring Geometry O Fully Automatic Temperature Calibration O Detection Of Sample Temperature Equilibrium Time O An Integrated Auto-Detection Of Measuring Systems And Chambers (The System Should Include An Automatic Check For Compatibility Between The Attached Measuring System And Installed Chamber) O Use A Quick Connect Coupling Mechanism For Attachment Of The Measuring Systems To The Motor Drive, So Repeating Zero Gap Determination Is Not Needed Even After Removing The Measuring System For Cleaning O Trimming Mirror (360° Blind Sample Spot Prevention) O Three-Point Support Of Device (Three Robust Feet For Tool-Free One Hand Alignment) O Three-Point Support For Mounting Of Measuring Cells (Wobble Prevention, No Misalignment After Changing Of Cells) O Ready For Dma In Torsion And Tension O Ready For Tribology O Ready For Powder Flow And Shear Rheology