Tenders Are Invited For Technical Inspection And Testing Services – Testing Of Electrical Equipment According To Dguv V3

Technical Inspection And Testing Services – Testing Of Electrical Equipment According To Dguv V3. Locations: - Helmholtz Center Hereon Max-Planck-Straße 1, 21502 Geesthacht (Excludes Buildings On The Site Of The Former Nuclear Facility) Other Locations: - Building Gitz B, Student Laboratory, Max-Planck-Straße 2, 21502 Geesthacht (Only The Areas Rented By Hereon) - Guesthouse Building 18, Otto-Hahnstraße 1, 21502 Geesthacht - Guesthouse Building 19, Tesperhuder-Straße 28, 21502 Geesthacht - Guesthouse Building 56, Otto-Hahnstraße 4, 21502 Geesthacht - Gerics (Climate Service Center In The Chilehaus) Fischertwiete 1, 20095 Hamburg (Only The Areas Rented By Hereon) - Helmholtz Center Hereon, Kantstraße 55, 14513 Teltow - Desy, Notkestr. 85, 22607 Hamburg (Only The Areas Rented By Hereon, Building 94, Building 47C, Building 46G, Building 221) - Moin Cc; Am Botanical Garden 14, 24118 Kiel (Only The Areas Rented By Hereon) - University Of Hamburg (Only The Area Rented By Hereon, Currently 2 Office Rooms) - New External Locations In The Future, Special Locations With Radiation Protection Requirements: - Frm Ii, Lichtenbergstrasse 1, Tu Munich, 85748 Munich Garching (Only The Areas Rented By Hereon) Before The Start Of Work, The Testing Personnel Employed Must Be Responsible For This Particular Location Must Be Presented To The Client With A Valid Category I Reliability Check In Accordance With The Atomic Energy Reliability Check Ordinance Atzuv. Only Personnel Who Are Occupationally Exposed To Radiation May Be Used To Carry Out The Tests In The Control Area. The Contractor Must Have A Permit In Accordance With Section 15 Of The Radiation Protection Ordinance. In Addition, A Radiation Protection Agreement (Delimitation Agreement) Must Be Concluded With The Client If This Does Not Exist. Before The Work To Be Carried Out Begins, The Personnel Employed Must Undergo Special Radiation Protection And Safety Instructions. Testing Of Electrical Equipment In Accordance With Din En 50678 (Vde 0701) Testing After Repair Din En 50699 (Vde 0702) The Basis For Testing Portable And Stationary Electrical Equipment Is Dguv Regulation 3, As Well As The Industrial Safety Ordinance In Conjunction With The Technical Rules For Operational Safety. Volume: Approx. 35,000 Pieces Of Electrical Equipment The Tests Include All Partial Tests In Accordance With Din Vde 0701 Or Din Vde 0702. Tests That Were Not Carried Out Or Partial Tests That Were Not Carried Out Must Be Justified And Documented In The Test Report. Electrical Equipment Is Divided Into: - Portable Devices: - Single-Phase Devices With Un=230V, - Three-Phase Devices With Un=400V - Stationary Devices Connected Via A Plug Connection: - Single-Phase Devices With Un=230V - Three-Phase Devices With Un=400V - Stationary Devices With A Permanent Connection: - Single-Phase With Un= 230V, - Three-Phase Devices With Un=400 V All Test Adapters And Aids Required For Measurement Must Be Provided By The Contractor. The Safety Check In Rooms Such As: Re