Tenders Are Invited For Delivery And Assembly Of Furniture And Sanitary Equipment For The Architecture Knowledge Center In Szklarska Poręba

1. The Subject Of The Order Is The Implementation Of The Task Entitled: Delivery And Assembly Of Furniture With Sanitary Equipment For The Architecture Knowledge Center In Szklarska Poręba.2.Details Regarding The Subject Of The Order Are Included In The Attachments: 1) List Of Furniture And Equipment - Annex No. 6 To Swz 2) Description Of The Subject Of The Order (Opz Furniture And Equipment) - Annex No. 6A To Swz3) List Of Sanitary Equipment - Annex No. 7 To Swz 4) Description Of The Subject Of The Order (Opz Sanitary Equipment) - Annex No. 7A To Swz5) Description Of Storage Cabinets - Annex No. 8 To Swz6) Building Design - Annex No. 9, 9A And 9B To Swz5.The Subject Of The Order Must Meet The Requirements Of The Dnsh (Do No Significant Harm) Principle, I.E. Do No Serious Harm, In Accordance With Art. 17 Of Regulation (Eu) 2020/852 Of 18 June 2020. The Dnsh Principle Means That At No Stage Of Contract Execution - From Production, Through Delivery, Use To Possible Disposal - May There Be Serious Damage To The Eus Environmental Goals, I.E.: 1) Climate Change Mitigation, 2) Adaptation To Climate Change, 3) Sustainable Management Of Water And Marine Resources, 4) Circular Economy (Circular Economy), 5) Pollution Prevention And Control6) Protection Of Biodiversity And Ecosystems.5.1.Transport Of Furniture To The Place Of Delivery And Assembly Should Be Carried Out In A Logistically Optimized Manner, Using Vehicles That Meet Exhaust Emission Standards Of At Least Euro 5 Or Higher, Which Will Reduce The Carbon Footprint Of The Investment.5.2.Wood-Based Furniture Elements Should Be Made In Compliance With The Principles Of Sustainable Forest Management And Have Certificates Such As Fsc Or Pefc.5.3.The Design Of Furniture Should Enable Easy Disassembly, Repair And Possible Replacement Of Parts, Which Will Extend Its Life Cycle And Facilitate Recycling.5.4.Mdf Chipboards Or Other Components Used For The Production Of Furniture Should Meet Formaldehyde Emission Standards (With Hygiene Class E1 Or Lower In Accordance With The En 717-1 Standard).5.5.Agents Used For Surface Finishing, Such As Varnishes, Paints, Adhesives, Must Not Contain Hazardous Substances And Must Meet Eu Criteria For Low Emissions Of Volatile Organic Compounds (Vocs).5.6.If The Installation Requires The Use Of, For Example, Adhesives, Paints, Etc., They Must Meet Standards Regarding The Lack Of Carcinogenic, Mutagenic Or Toxic Substances (In Accordance With The Reach Regulation).6.At Each Request Of The Ordering Party, The Contractor Is Obliged To Present Documents Confirming The Above Parameters (E.G. Safety Data Sheets, Fsc/Pefc Certificates, Declarations Of Conformity Of Furniture Manufacturers)7.The Contractor Is Responsible For The Removal And Disposal Of Waste After The Installation Of Furniture And Equipment, In Accordance With The Applicable Provisions Of The Waste Act.8.The Contractor Is Obliged To Provide The Ordering Party With Bdo Cards Or Other Documents Confirming Proper Was