Tenders Are Invited For Purchase And Delivery Of Municipal Equipment For The Needs Of The Kraśnik Municipality

Task 1 (Part 1) Purchase And Delivery Of A Chipper, Sand Spreader, Plow, Weights And A Working Head With A Circular Saw For The Needs Of The Kraśnik Commune. Specification Of The Chipper:• Brand New• Disc Chipper Intended For Shredding Wood, Branches And Trunks With A Diameter Of Up To Min. 12 Cm. • Equipped With An Independent Hydraulic System With Its Own Pump And Oil Tank. • Drive Of The Cutting Unit Transmitted From The Tractor Via The Power Take-Off Shaft. • Equipped With A Hydraulically Driven Feed Shaft/Rollers. • Possibility To Adjust The Feeding Speed To The Type Of Material Being Shredded Using Gradual Adjustment. • The System Should Have A Function Of Reversing The Material In The Event Of Blockage. • Emergency Stop. • Cutting Disc With A Diameter Of Not Less Than 55 Cm And A Mass Of At Least 65 Kg. • The Obtained Chips Are Approximately 20-50 Mm In Size. • Adjustable Support Knife Allows You To Set The Appropriate Cutting Gap Depending On The Working Conditions. • Swivel Discharge Hopper With The Possibility Of Turning 360°. • Discharge Pipe With A Height Of Not Less Than 180 Cm. • Possibility Of Folding The Throat For Transport. • Suitable For Installation On A Tractors Three-Point Suspension System. • Min. 4 Double-Sided Knives With A Counter Blade/Counter Blades Specifications Of The Mounted Spreader:• Brand New• Feed Hopper Made Of Stainless Steel• Tank Capacity Min. 550 Kg• Disc-Centrifugal Sowing System• Spreading Working Width With Municipal Attachment 1.2-5 M• Pto Shaft Revolutions 540 Rpm• Tarpaulin• Roller Pto• Filter Mesh Snow Plow Specification:• Brand New• Width 3 M.• Working Width Min. 2.60/Max. 3.0 M.• Cross-Terrain Following• Amortized Blade• Category Ii Three-Point Linkage Mounting• Slides• Rubber Scraper Strip Min. 50 Mm.• 12V Electrical Connector (3 Pin Connector To The Socket Mounted On The Three-Point Linkage)• Lighting• Two Independently Controlled Mouldboards• Stepless Hydraulic Adjustment Of The Mouldboard From The Controller• Moldboard Height Min. 1.1 M. • Steering Angle 30O • Hydraulic Hoses Included Specification Of Rear Wheel Weights: • Brand New • For Deutz-Fahr 5125 Tractor • 300 Kg, 150 Kg Per Side • With Assembly Kit And Assembly At The Place Indicated By The Ordering Party Specification Of The Working Head With A Circular Saw: • Brand New • Fully Compatible With The Samasz Arm Kwt 550 Ep• Working Width 1.80M - 2.00M• Number Of Circular Saws 3 Pieces• Diameter Of Circular Saw Min. 600 Mm• Maximum Diameter Of Cut Branches Up To 120 Mm• Head Weight Up To Max. 200 Kgthe Remaining Description Of The Subject Of The Order Was Specified In The Swz