Tenders Are Invited For Services Related To Profiling Municipal Roads With A Road Grader And A Self-Propelled Roller

Common Procurement Dictionary: Cpv 50800000-3 Various Repair And Maintenance Servicescpv 50000000-5 Repair And Maintenance Servicescpv 45500000-2 Rental Of Machines And Equipment With Operator Support For Construction And Water And Civil Engineering Works. Ordering Party: Kruszwica Commune. Completion Date: 2 Months From The Date Of Conclusion Of The Contract.The Subject Of The Order Includes Grading And Compaction Using A Self-Propelled Road Grader And A Self-Propelled Vibrating Steel Roller, Min. Pressure 10 Tons. Rolling With A Road Roller Should Be Performed Each Time The Grader Passes. Rolling With A Road Roller Should Be Performed Each Time After The Grader Collects Material.2.Profiling Of Dirt Road Surfaces Using A Motor Grader On Roads (Dirt, Gravel, Cinder Blocks). Profiling Of Municipal Roads Involves Correcting The Cross-Section Of The Road And Leveling Its Unevenness In Order To Improve The Drainage Of The Surface. During Grading, The Grader Should Remove Transverse Irregularities And Smooth Out Potholes And Ruts, And If Ponding Water Is Found, Make Drainage Grooves.3.The Contractor Is Obliged To Remove Stones, Debris (Over 5 Cm In Diameter), Etc. That May Be Torn Out From The Surface Of Profiled Roads. Due To The Different Types Of Surfaces And The Varying Degrees Of Surface Damage, The Number Of Grader Passes Should Be Adjusted To Obtain The Appropriate Road Profile.4. The Total Length Of Road Sections Subject To Profiling Is 200 Km.5.The Total Length Of Road Sections Subject To Road Profiling Is 200 Km.6.The Detailed Location Of The Roads Covered By The Order Is Presented On The Map Constituting Annex No. 6 To Swz.7.The Contractor Must Have Equipment Approved For Operation In Accordance With The Applicable Legal Provisions Enabling The Execution Of The Order8.The Minimum Width Of The Graders Blade Is 3.60 M, The Minimum Power Of The Grader Expressed In Horsepower Is 120.9.Minimum Weight Of The Self-Propelled Vibrating Steel Roller Min. 10 Tons.10.The Ordering Party Reserves The Right To Limit The Order For Road Profiling With A Motor Grader To 100 Km Of Roads And To 100 Km Of Road Roller Work.11.Road Profiling Should Be Performed While Maintaining Optimal Road Surface Humidity.12.During The Implementation Of The Works, The Contractor Will Comply With Occupational Health And Safety Regulations. The Contractor Is Obliged To Secure And Mark The Area Where Works Are To Be Carried Out On The Road. The Vehicle Performing The Work Should Be Marked In Accordance With The Regulations To Ensure Road Traffic Safety.13.The Contractor Is Fully Liable For Damages And Accidents Resulting From Incorrect Execution Of The Order. During The Execution Of This Order, The Contractor Will Be Obliged To Have Civil Liability Insurance For Damages And Consequences Of Accidents.14.The Contractor Is Obliged To Exercise Particular Care During The Execution Of The Order, Including Paying Particular Attention To The Existing Infrastructure In The Road, E.G., San