Tenders Are Invited For Renovation Of Garages In The Military Complex At Ul. Kulasa 8 In Poznań., - Case No.: 56/Z/2026

The Scope Of Work Concerns The Renovation Of The Building. It Is To Include: Renovation Of The Electrical Installation• Complete Dismantling Of The Existing Electrical Installation.• Construction Of A New Power Supply For The Garage Building With A Ykxs 5X10 Cable; The Route Between The Buildings To Be Determined At The Implementation Stage.• All Wiring In The Garage Building Should Be Made P/T.• Use P/T Equipment With Ip44.• Lighting Fixtures With Parameters Not Worse Than In The Bill Of Quantities.• Install The Main Switchboard In Garage No. 1 And A Sub-Switchboard Powered From The Main Switchboard In Garage No. 9; Both Switchboards With Ip 65.• Switchgear Equipment Based On The Equipment Specified In The Bill Of Quantities.• 24V Safe Installation In Car Ducts.• Electrical Measurements. General Construction Works• Forging Sockets 1 Brick Deep. In Brick Walls With Lime Mortar For Steel Beams In Order To Determine The Resting Place Of Their Ends And Decide What Type Of Box And Guide Assembly To Use.• Reflecting Internal Plasters With Cement Mortar In Strips Up To 30 Cm Wide• Carving Out Of The Wall Steel Door Frames Or Window Grates With An Area Of ​​Up To 2 M2• Carving Out Of The Wall Steel Door Frames Or Grates With An Area Of ​​Over 2 M2• Complementing The Walls With Bricks 1/2 Brick Thick. Or Filling Up The Holes In The Walls With Cement-Lime Mortar. • Carving Out Shreds In The Cross-Section Of The Wall With A Thickness Of 1/2 Brick. On Cement Mortar• Complementing Ordinary External Plasters, Category Iii, On Substrates Made Of Bricks, Ceramic Hollow Bricks, Gas And Foam Concrete (Up To 2 M2 In One Place)• Removing Concrete Unevenness With A Chipping Depth Of Up To 1 Cm On Walls Or Floors• Leveling Layers Under Cement Mortar Floors, 20 Mm Thick, Troweled Sharply• Tile Floors Made Of Artificial Stones; 40X40 Cm Tiles Laid With Glue Using The Usual Method• External Stucco Plasters Speckled On Flat Walls And Horizontal Surfaces (Balconies And Loggias) Made By Hand. Plasters On The Area Up To 5 M2• Installation Of Large-Size Industrial Roller Doors With Electric Drive, Dimensions 3.9 M High, Width 3.80 M - 2,000 Pcs.• Installation Of Roller Garage Doors With Electric Drive, Dimensions 2.5 M Wide, 2.65 M High, Mounted On The Wall From The Outside, Electrically Operated With A Motor, With Emergency Opening Option (Switch On The Wall) - 8,000 Pcs.• Scraping And Washing Off Old Paint In Rooms With A Floor Area Of Over 5 M2 - Work At A Height Of 5-10 M.• Priming Substrates With Ceresit Ct 17 And Atlas Uni Grunt - Vertical Surfaces.• Priming Substrates With Ceresit Ct 17 And Atlas Uni Grunt - Horizontal Surfaces.• Painting With Paints Twice Emulsion Of Old Internal Plasters Of Ceilings.• Double Painting Of Old Plasters Of Internal Walls With Emulsion Paints.• Facing The Walls With Glazed Tiles 15X15 Cm.• Framing The Channel Inside The Building With An Angle Frame.• Replacing The Formwork - 32 Mm Thick Boards With Joints (Covering The Garage Channel)• I