Tenders Are Invited For Resurfacing Works – State Roads In The Nordhausen District; Removal Of Road Damage, Sectional Resurfacing - Framework Agreement 2026/2027

Resurfacing Works – State Roads In The Nordhausen District; Removal Of Road Damage, Sectional Resurfacing - Framework Agreement 2026/2027. This Is A Framework Agreement In Accordance With Section 4A Eu Vob/A. This Means That The Conditions For Individual Orders Should Be Determined Within The Term Of The Framework Agreement. This Applies In Particular To The Proposed Prices. The Framework Agreement Is Concluded With A Company. The Envisaged Order Volume Was Determined As Accurately As Possible, But Is Not Finalized. There Is No Entitlement To A Complete Performance Of The Service According To The Service List. The Scope Of Services Can Increase Significantly For Individual Positions, But It Can Also Be Eliminated Completely. It Is Planned To Carry Out Up To Five Individual Measures In The Form Of Spatially Defined, Connected Route Sections Within The Basic Term (November 9, 2026 - December 31, 2027). For The Calculation, At Least 3 Individual Orders Can Be Assumed. These Are Already Specifically Known And Concern The Following Route Sections: L 3080 Nordhausen - Bielen Vnk 4530 014 Nnk 4531 049Y L 3080 Bielen - As Heringen Vnk 4530 014 Nnk 4531 049Y L 3080 As Heringen - Urbach Vnk 4531 049X Nnk 4531 012 The Quantities Stated In The List Of Services Are Based On Empirical Values From Comparable Measures And Represent Non-Binding Estimated Quantities. They Are Used Exclusively To Calculate The Offers. If A Contract Is Extended (According To Point 5.1.1 Options), It Can Be Assumed That At Least 1 And A Maximum Of 3 Individual Measures Will Be Commissioned Per Extension Year. The Renovation Is Essentially Carried Out Through The Construction Of New Bituminous Road Structures. Depending On The Respective Damage Pattern, The Scope Of Renovation Ranges From The Renewal Of Individual Asphalt Layers To The Complete Renewal Of The Superstructure Including The Base, Binder And Top Layer. The Required Opening Or Milling Depths Can Be Between 4 Cm And Approx. 25 Cm And Are Determined By The Client On A Case-By-Case Basis.