Request For Quotation Household Goods

Square Pipe With A Cross Section Of 50×50 Mm According To Gost 8639-82. Thickness Of At Least 3 Mm. Pipe Length Of At Least 6 Meters., Gland Braided Graphite Packing With A Cross-Section Of At Least 12X12 Mm. Braided Graphite (Often Reinforced With Fiberglass, Carbon Or Fluoroplastic Filaments). Braided Graphite (Often Reinforced With Fiberglass, Carbon Or Fluoroplastic Filaments). Unit Of Measurement - Coal., Square Pipe With A Cross Section Of 40×40 Mm According To Gost 8639-82. Thickness Of At Least 3 Mm. Pipe Length Of At Least 6 Meters. Warehouse, Digital Cable Marker 1, 2. On The Latch, Galvanized Sheet With A Thickness Of At Least 1 Mm, Size Of At Least 1.0 X 2.0 M. Gost 14918-80, Radial Ball Bearing No. 307. (Boiler Room), Bolt With Nut/Washer Diameter Of At Least 16 Mm. Gost 7798-70, For The Work Of The Surgical Department Drill Bit For Concrete, Length No Less Than 10 Cm, Diameter No Less Than 8 Mm, For The Work Of The Surgical Department Drill Bit For Concrete, Length No Less Than 10 Cm, Diameter No Less Than 6 Mm, Ball Bearing, Radial, Single Row No. 621250 For Network Pump (Boiler House), Construction Netting Mesh. Cell Mesh Is At Least 4X4 Mm, Wire Diameter Is At Least 3 Mm (Karagash). Gost 23279-2012., Radial Ball Bearing No. 310. (Boiler Room), Radial Ball Bearing No. 309. (Boiler Room), Dielectric Latex Gloves, Orange, Bolt With Nut/Washer Diameter Of At Least 14 Mm. Gost 7798-70, Glass Thermometer With Attached Scale Plate. Technical Liquid Thermometers (Tlt) Are Glass Instruments With An Embedded Scale Plate, Designed For Accurate Temperature Measurement In Air-Steam-Gas Power Plants And Pipelines. Design: A Glass Capillary Tube With A Reservoir Placed In A Protective Frame And A Scale Plate Inserted Inside. Operating Principle: Changing The Volume Of Thermometric Liquid (Kerosene, Mercury Or Other Composition) When Heating Or Cooling The Medium. Temperature Range: Measurements Are Carried Out In The Range From -50 °C To +500 °C Depending On The Specific Design Of The Device. Use: The Lower Part Of The Thermometer Is Immersed Directly In Measured Medium, And For Installation At Industrial Facilities Special Protective Frames Are Used, Letter Cable Marker L1, L2, L3, N, Pe. On The Latch, Steel Sheet With A Thickness Of At Least 2Mm, Dimensions Of At Least 1250X2500mm. Gost 19903-2015., Scoop Shovel With Handling For Boiler Room. Working Part Material: Rail Steel. The Total Length Is At Least 37 Cm. Additional Information: At Least 4 Stiffeners. The Width Of The Working Part Is At Least 300 Mm.