Tenders Are Invited For Renovation Of The Municipal Road In Łąg - Kolonia

The Subject Of The Order Is: Renovation Of The Municipal Road In Łąg - Kolonia. The Subject Of The Order Includes The Renovation Of The Surface Of The Municipal Road In Łąg - Kolonia, I.E.: 1. Demolition Of The Naves Bituminous Thickness 5 Cm - 160.00 M22. Construction Of A Trough In The Ground Of Category Iv Along With Profiling And Compaction Of The Substrate - Average Thickness 35 Cm (40X4.3) - 236.50 M23. Foundation Made Of Cement Stabilization Rm 2.5, 15 Cm Thick, With Profiling And Compaction (40X4.3) - 236.50 M24. Foundation Made Of Kłsm C90/3, 20 Cm Thick, With Profiling And Compaction (40X4.2) - 168.00 M25. Cleaning And Sprinkling With Emulsion (40X4.2) - 168.00 M26. Construction Of The Wearing Course From The Ac11 S Mixture, Thick. 5 Cm With Transport (According To Kr 1-2 According To Wt-2014) - 40 M Section (40X4.1) - 164.00 M27. Partial Renovation Of The Naves Bituminous Up To 5 Cm Thick With Cutting Out And Carving Out Damaged Areas Along With Sprinkling - 30.00 M28. Mechanical Cutting Of Roadsides With A Thickness Of Up To 35 Cm With Profiling And Compaction - 300.00 M2 Note. The Exact Location Of The Works Will Be Indicated By The Ordering Party When Handing Over The Construction Site. Ii. Other Information For The Contractor.1. Before Starting The Works, The Contractor Will Develop A Traffic Organization Plan For The Duration Of The Works, Which Will Be Approved By The Relevant Authorities And Road Managers.2. Before Starting The Work, The Contractor Will Agree With Zuk Sp. Z O. O. In Czersk, Location Of Wells And Valves Of The Water And Sewage Network. And Will Adjust The Height In Relation To The Future Road Surface, And After Completing The Work, It Will Present The Employer With A Report Written With A Representative Of Zuk Czersk Confirming The Correct Implementation Of This Adjustment. 3. In The Case Of Bituminous Works - Where The New Surface Meets The Existing One, The Cut Vertical Edges Of The Surface Should Be Smeared With Road Asphalt.4. The Subject Of The Order Was Specified In Detail In The Technical Specification For The Execution And Acceptance Of Works And, Additionally, In The Bill Of Quantities Constituting Annexes To Swz.5. If In The Description Of The Subject Of The Order, Design Documentation, Technical Specifications For The Execution And Acceptance Of Works, Bills Of Quantities, Explanations For The Tender, The Ordering Party Indicates The Names Of Manufacturers Of Materials, Devices, Products, Etc., This Means That The Contractor May Adopt The Solutions Indicated By The Ordering Party Or Equivalent. However, The Contractor Must Demonstrate That The Materials, Devices, Etc. Used Are Equivalent. The Ordering Party Describes The Subject Of The Contract By Reference To Standards, Technical Assessments, Technical Specifications And Technical Reference Systems Referred To In Art. 101 Section 1 Point 2 And Section 3 Of The Public Procurement Law Allows Solutions Equivalent To Those Described, And Such A Reference