Tenders Are Invited For Construction Of A Warehouse Building Intended For A Civil Defense Warehouse

The Subject Of The Order Is: Construction Of A Warehouse Building Intended For A Civil Defense Warehouse Location: Łubnice, No. Plots: 280/1, 280/2 A. The Scope Of The Order Includes, Among Others: − Securing The Construction Site And Organizing The Construction Site. − Construction Of A Warehouse Building For A Civil Defense Warehouse With The Following Parameters:• External Foundation Strips, 60 Cm Wide - In Accordance With The Construction Drawing And Construction Details In The Technical Design• Cement Floors With Plinths Troweled Smooth - Industrial Floor With Dispersed Reinforcement. Concrete C30/37 With Corundum Topping, Thickness. 15 Cm• Construction Of The Building Walls: 24 Cm Thick Walls With A Height Of Over 4.5 M, 59 Cm Long Aerated Concrete Blocks With Adhesive Mortar + 20 Cm Of Polystyrene With Facade Plaster. Heat Transfer Coefficient U=0.137W/Sq M. All Structural Walls Should Be Topped With Reinforced Concrete Rings - In Accordance With The Construction Drawing In The Technical Design Part.• Mechanically Lifted Garage Doors• Roof Structure. The Building Is Covered With A Gable Roof With An Angle Of Inclination Of 15°. Truss Structure - Roof Truss Structure With Elements Weighing Up To 1 T, Protected Against Corrosion. • Covering - Light Roof Cladding Made Of Sandwich Panels. 10 Cm Assembled Using The Traditional Method • Roof Flashing, Gutters And Downpipes. • Rain And Snowmelt Water From The Building Will Be Discharged Via Pipes To The Investors Plot. • Insulation: Vertical Bituminous Coating Moisture Insulation - Cold Made From Asphalt Emulsion 2 X Thermal And Anti-Sound Insulation Made Of Vertical Polystyrene Boards On Adhesive Thickness. 10 Cm• Vertical Insulation Of Foundation Walls Made Of Dimpled Foil Without Priming The Surface• Gravity Ventilation. Ventilation Through Ventilation Chimneys, Air Flow Ensured By Installing Grilles In Garage Doors.• Finishing: Internal: Standard Internal Plasters Of Category Iii, Hand-Made. Double Painting With Latex Paints Of Internal Surfaces - Walls With Primer. External: Insulation Of Aerated Concrete Walls With Polystyrene Boards - Stopter System - Using Ready-Made Adhesive Mortars Along With Preparation Of The Substrate And Manual Preparation Of Facade Plaster From A Ready-Made Dry Mixture. • Characteristic Parameters Of The Building. Volume - 810.00 M3 Built-Up Area - 180.00 M2 Total Area - 180.00 M2 Height - 6.44 M Length - 15.00 M Width - 12.00 M Number Of Floors - 1St Floor Above Ground − Electrical And Ventilation Installation 1. The Order Should Be Made In Particular In Accordance With The Design Documentation, Technical Specification For The Execution And Acceptance Of Works And Other Documents Constituting Annex No. 10 To The Swz, Taking Into Account The Provisions Of The Swz And The Contract (Annex No. 9 To The Swz). 2. A Detailed Description Of The Subject Of The Order Includes In Particular: 1) Design Documentation, 2) Technical Specification For The Execution And Acceptanc