Tenders Are Invited For Development Of The Area Near The Community Center In Podlesie Rabsztyńskie

The Subject Of The Order Is The Development Of The Area On Plot No. Gr. 178/1, At The Community Center In Podlesie Rabsztyńskie. 3. The Scope Of The Subject Of The Order Includes The Execution Of Construction Works Consisting Of: A) Earthworks Under The Hardened Area On An Area Of ​​Approximately 155 M2, In Accordance With The Graphic Attachment For The Arrangement Of Layers After Compaction: Lower Layer 20 Cm, Upper Layer 10 Cm, Openwork Slabs Minimum 10 Cm. Removal Of Excess Excavated Material And Disposal; B) Construction Of The Lower Foundation Layer 20 Cm Thick After Compaction From Aggregate With A Fraction Of 4-31.5 Mm; C) Construction Of The Upper Foundation Layer, 10 Cm Thick After Compaction, Using Aggregate Of 2-8 Mm Fraction; D) Demolition Of A Concrete Slab With A Thickness Of About 10 Cm, An Area Of ​​​​Approximately 4.0 M2, And The Walls On Which The Concrete Slab Is Placed. Depth Of Wall Demolition Of At Least 50 Cm - So That All Layers Of The Foundation And Surface Can Be Made Of Openwork Slabs; E) Making The Backfill Along With Compacting And Leveling The Area After The Dismantled Walls And Concrete Slab For The Construction Layers, Hardened Area, Backfill; F) Hardening The Plot On An Area Of Approximately 155.0 M2 In The Arrangement Of Layers As Specified In Point A) G) Limiting The Hardened Area Curbs, An Inrun Curb On The Road Side With A Length Of Approximately 14.5 M With An Opening Of 2.0 Cm Above The Ground On A Concrete Bench, And On Three Sides For A Length Of Approximately 21.0 M With A Concrete Curb Of 15 Cmx30 Cmx100 Cm With An Uncovering Of 12.0 Cm On A Concrete Bench With Resistance; H) Filling The Holes Of The Openwork Slabs With Aggregate Of 8.0 Mm Fraction To The Full Thickness;I) Dismantling The Information Board From The Fence Pole,J) Dismantling The Existing Fence On The Road Side On A Section Of Approximately 32.40M;K) Constructing A New Panel Fence On A Section Of Approximately 32.40M. 3D Fence Panel Made Of Wire With A Diameter Of 5 Mm. All Fence Elements Are Galvanized, Powder Coated, Dark Green. The Panel Is Attached To The Posts With Clamps. Posts With A Rectangular Cross-Section Of 40Cm X 60Cm Or A Square Cross-Section Of 60Cm X 60Cm Are Attached To The Existing Foundation Using A Single Manufacturers System. Spacing Of The Posts At The Same Distance Adapted To The Length Of The Panel. The Contractor Will Build The Fence Using A System According To One Manufacturer. The Height Of The Panel Fence From The Ground Level Is Approximately 150.00 Cm, Adjust The Height To The Existing Height Of The Fence. Installation Of An Information Board In A Place Indicated By The User. It Should Be Mounted On A Foundation Made By The Contractor. The Existing Wicket Should Be Dismantled For The Time Of Installation Of The New Fence And Reassembled To The Posts - Without Replacing The Wicket. All Works Should Be Carried Out In Accordance With Applicable Regulations And The Principles Of Technical Knowledge And Constructio