Request For Quotation Flange Circulation Pump

Gost Iec60335-2-51-2012 Flange Circulation Pump (For Hot Water Systems). Parameter Name Required Technical Characteristics (Values, Ranges) Pump Type Circulation, With A “Wet” Rotor Purpose For Heating And Hot Water Systems Connection Type Flange Nominal Diameter Of Connection Connector (Dn) Not Less Than 80 Mm (Dn80) Mounting (Center-To-Center) Length From 340 To 360 Mm Maximum Flow (Productivity) At Least 60 M³/H (Or In The Range From 60 To 65 M³/H) Maximum Head At Least 11 Meters (Or In The Range From 11 To 12 Meters) Maximum Operating Pressure Not Less Than 10 Bar Temperature Of The Pumped Liquid The Operating Range Should Include Values From -10 °C To +120 °C Requirements For The Pumped Liquid Clean Water Without Solid Inclusions And Mineral Oils. Glycol Content Up To 30% Is Allowed. Number Of Rotation Speeds At Least 3 Speeds (Manual Switching) Maximum Power Consumption No More Than 1450 W Power Supply Parameters Three-Phase Power Supply, Rated Voltage 3X400v (Or 3X230v), Frequency 50 Hz Motor Protection Class Not Lower Than Ip 42 Insulation Class Not Lower Than F Shaft Position When Installed Horizontal Additional Delivery Terms: 1. Quality And Condition: The Product Must Be New, Not Used, Not Refurbished, Free From Third Party Rights. 2. Contents: The Pump Must Be Supplied Complete With Mating Flanges, Gaskets And Fasteners Necessary For Installation. 3. Documentation: Upon Delivery, The Supplier Is Obliged To Provide A Warranty Card (Warranty For At Least 12 Months), A Product Passport And Operating Instructions In Kazakh And Russian. 4. Place Of Delivery: Almaty Region, Talgar District, Talgar Central District Hospital.