Tenders Are Invited For Renovation Of The Training Workshop Building - Stage Ii (Last) Of The Ohp Education And Upbringing Center In Oleśnica - Ii Procedure

The Subject Of The Proceedings Is The Renovation Of Part Of The Training Workshop Building Managed By The Education And Upbringing Center Of The Voluntary Labor Corps In Oleśnica. The Buildings Volume Is 1,140.00 M3 And The Usable Area Is 220.47 M2. The Building Is A Single-Story Building Without A Basement And Is Located On A Fenced Area Of ​​0.2011 Ha, Connected To A Public Road From Ul. Wałowa. The Plot On Which The Reconstruction Of The Building Is Planned Is Fully Developed And Includes A Training Workshop Building And A Free-Standing Chimney. The Plot Area Is Fenced And Has A Hardened Surface. It Is Equipped With: - Existing Exits From The Public Road - Access To And Access To The Building - Water Supply Connection - Sewage Connection - Energy Connection - Low-Voltage Installation Connection Stage Ii Consists In Completing The Renovation Of The Training Workshop Building, To The Extent Remaining To Be Completed, In Accordance With The Design Documentation And The Current Condition Of The Facility. The Scope Of The Order Includes In Particular General Construction Works, Finishing Works And Works In The Field Of Sanitary Installations, Ventilation, Water, Sewage And Electrical Installations. The Subject Of The Order Also Includes Performing The Necessary Tests, Checks, Measurements And Tidying Up The Area And Rooms After The Completion Of The Works. The Order Does Not Include The Delivery And Assembly Of Technological Equipment For The Catering Workshop. The Minimum Quality Parameters Of Tiles, Fittings, Electrical Equipment And Other Finishing Materials Are Specified In The Design Documentation. Stoneware Tiles Should Meet The Requirements For Catering And Hairdressing Establishments, In Particular They Should Have Increased Parameters Of Abrasion Resistance And Anti-Slip Properties. It Is Required That The Supply And Exhaust Air Handling Unit Intended For Room L1/5 Be Equipped With An Electric Heater. As Part Of The Order Execution, It Is Necessary To Provide For The Connection Of A Technological Heating Installation To The Heater Of The Supply Air Handling Unit Located In Room L1/16. If It Is Necessary To Ensure Proper Power Supply To The Heater, It Is Allowed To Replace The Existing Collectors In The Boiler Room, As Long As It Is Necessary To Properly Perform The Installation And Achieve The Required Operating Parameters. The Ordering Party Allows The Use Of Equivalent Solutions With The Parameters Included In The Design Documentation. The Ordering Party Informs That From September 1, 2026, The Building Will Be Partially Used - One To Two Days A Week, Practical Training Classes In The Blacksmith Profession Will Be Held There. The Blacksmiths Workshop Is Located In The Part Of The Building Renovated As Part Of Stage I. Participants Of The Classes And The Instructor Will Use A Separate Entrance To The Building, In A Way That Does Not Hinder The Work Covered By Stage Ii Of The Renovation. The Installation Of The Ventilation Unit Located In