Tenders Are Invited For Supply And Installation Of Road Markings In West Flanders - 3 Lots - Lot 1: Supply And Installation Of Road Markings In The District 311 Bruges Lot 2: Supply And Installation Of Road Markings In The District 312 Kortrijk Lot 3: Supply And Installation Of Road Markings In The District 315 Ostend

Preparatory Works (See Also Glossary In Ii Technical Section, Markings) Where Appropriate, The Removal Without Damaging The Pavement Of Some Continuous And Non-Continuous Longitudinal Markings, Arrows And Hatches, Stop And Bus Stops, Cross Markings, Pedestrian Crossings, Etc. Where Appropriate, The Prior Thorough Cleaning Of The Surfaces To Be Marked, Including The Immediate Removal Of All Waste. Where Appropriate, The Removal Of Loose Parts Of Thermoplastics. The Work That Precedes The Application Of The Markings, Such As Drying And Sweeping. Tracing New Markings. Where Appropriate, Supplying And Applying An Adhesive Layer To Concrete And Bituminous Road Surfaces. Where Appropriate, Applying Primer To Existing Old Markings. Applying Durable Road Markings. The Application Of Cycle Path Coating Over The Full Width Of The Cycle Paths At Intersections And Roundabouts. The Installation Of Cycle Lanes. The Dimensions Of The Road Markings Comply With The General Circular Regarding Road Signalization. Application Of Road Paint Marking. Applying Thermoplastic Or Cold Plastic Markings With Improved Retro-Reflection At Night In Rainy Weather And Wet Road Surfaces. Unscheduled Work, Night Work Or Weekend Work For Road Markings. The Basic Equipment For Site Signaling For 6Th Category Works, Including Minor Additions, Is The Responsibility Of The Contractor Is On The Roads With A Permitted Speed Of More Than 90 Km/H, Will Only Be Reimbursed Separately For Unforeseen Works, Which Are Not Expressly Stated In The Service Order. Provision Of Personnel, Hand Tools And Equipment For The Execution Of Minor And Unforeseen Works According To The Service Order. All Works To Be Carried Out Outside Normal Working Hours According To The Service Order, Count As A Fixed Additional Cost And Will Be Reimbursed Separately According To The Planned Item. The Maintenance Of The Works During The Guarantee Period. Measurements The Contractor Will Check The Daytime Visibility (Qd) And The Measure Night Vision (Rl).