Tenders Are Invited For Major Overhaul Of The Komatsu Wa 320-6 Wheel Loader, Chassis Number H62216, Year Of Production 2015

1. The Subject Of The Order Is A General Overhaul Of The Komatsu Wa 320-6 Wheel Loader With Chassis Number H62216, Year Of Production 2015 (Hereinafter Referred To As The Loader). 2. The Contractor Is Obliged To Collect The Machine From The Ordering Party And, After Completing The General Overhaul, Deliver It To The Ordering Partys Office At His Own Expense And Risk. 3. The Contractor Is Obliged To Carry Out An Operational Test Of The Loader By An Employee Of The Ordering Party, Which Consists In Performing A Full Work Cycle Of The Loader Three Times (Filling The Bucket, Driving With A Full Bucket, Emptying The Bucket And Driving With An Empty Bucket) Along With A Test Drive. Successful Performance Of The Operational Test Is A Condition (Condition Precedent) For Acceptance Of The Charger By The Ordering Party.4. The Ordering Party Reserves That On The Day Of Acceptance, The Ordering Party May, At Its Own Expense, Ensure The Participation Of An Authorized Service Unit Of The Manufacturer In Order To Carry Out Tests Confirming That The Operating Parameters Of The Machine Referred To In Section 6 Correspond To Factory Parameters.5. After A Major Overhaul Of The Machine, The Pressures In The Hydraulic System And The Engine Operating Parameters Must Meet The Factory Parameters.6. Technical Parameters: Specified In The Swz Content In Chapter Iii.7. Scope Of Major Overhaul: 1) Combustion Engine - Planning Of The Head With Replacement Of Valves, Guides And Seals - Alignment Of The Engine Block - Grinding Of The Crankshaft - Replacement Of Connecting Rod Bushings - Regeneration Of The Turbocharger And Starter - Replacement Of Pistons, Bushings, Pins, Rings With New Ones - Replacement Of Main And Connecting Rod Bearings With New Ones - Replacement Of Water And Oil Pumps With New Ones - Replacement Of New Injectors And Fuel Pipes - Replacement Of The Engine Controller With A New One - Replacement Of The Electrical Harness - Replacement Of The Electrical Sensors - Replacement Of The Tensioners, Belts And Thermostat - Replacement Of The Shaft Seals With New Ones - Replacement Of The Valve Levers With New Ones - Replacement Of The Engine Seals With A New One - Replacement Of The Exhaust System With A New One - Replacement Of The Oil Pressure Valve With A New One - Replacement Of The Metal-Rubber Elements Of The Engine Suspension - Cleaning The Interior Of The Fuel Tank - Replacement Of A Set Of Filters - Capacity Of The Oil Pan Is 23 Liters - Initial Run-In Of The Engine After A Major Overhaul2) Engine Cooling System - Replacement Of Wide Core Cooling Cores With New Ones - Replacement Of Water Pipes With New Ones - Replacement Of Radiator Mounting Cushions With New Ones - System Capacity Is 25 Liters3) Boom Working Frame - Replacement Of Pins And Bushings With New Ones - Verification Of The Bushing Mounting Holes - Straightening And Welding Of The Frame Structure4) Front And Rear Support Frame - Replacement Of New Pins And Joint Bearings - Replacement Of The S