Tenders Are Invited For Reconstruction And Renovation Of Roads In Msc. Oblęgorek, Promnik And Oblęgór, Strawczyn Commune

Part 1. Renovation Of The Municipal Road Ul. Landscape On Plot No. 647 (No. 648 - Intersection) In Msc. Oblęgorekthe Subject Of The Order Is The Renovation Of The Municipal Road Ul. Landscape On Plot No. 647 (No. 648 - Intersection) In Msc. Oblęgorek At A Length Of 317 Meters. The Purpose Of The Planned Communication Investment Is To Improve The Safety Of Road Traffic Through The Construction Of A New Road Surface And Roadside Maintenance. The Function Of The Facility Is To Provide Communication Services And Improve Safety By Providing A Bituminous Surface. Assumptions Of The Road Being Renovated: Length Of The Section: 317 M, Traffic Category - Kr1, Design Speed Vp - 30 Km, Number Of Roadways - 1, Number Of Lanes - 1, Width Of The Road - 3.00 M. Ballast Roadside - 0.50 M. Construction Of Road Surface Renovation On Road Sections From Km 0+000.00 To Km 0+317.00 + 5M (Intersection): - Construction Of The Base From The Mce Mixture Using The Deep Cold Recycling Method, Layer Thickness After Compaction Is 25 Cm, Width 3.10 M - Construction Of The Asphalt Concrete Surface, Reinforcing Leveling Layer Of Concrete. Asphalt Thickness 3 Cm, 3.10 M Wide - Surface Made Of Asphalt Concrete, Binding Layer, Reinforcing Layer Of Concrete. Asphalt Thickness 4 Cm, 3.10 M Wide. - Construction Of Asphalt Concrete Surface, Asphalt Concrete Wearing Course, Thick. 4 Cm, 3.00 M Wide. Reinforcing The Roadsides With Mechanically Stabilized Crushed Aggregate 0-31.5 Mm, 8 Cm Thick And 50 Cm Wide. The Contractors Obligations Also Include The Development, Agreement And Approval Of The Temporary Traffic Organization Design For The Duration Of The Works. The Subject Of The Order Must Be Performed Properly, In Accordance With Construction Practice And Applicable Regulations. The Detailed Scope Of The Subject Of The Order Is Specified In The Technical Documentation And The Bill Of Quantities, Which Constitute An Integral Annex To This Swz.1) The Subject Of The Order Is Specified In The Technical Documentation, And The Works Specified In The Bill Of Quantities And Not Included In The Documentation Should Also Be Valued. In Addition, Works Not Included In The Bill Of Quantities But Included In The Technical Documentation Are Also Subject To Valuation.2) The Contractor Should Read The Technical Documentation And Other Documents In Order To Determine The Scope Of Works Necessary To Achieve The Result. 3) The Subject Of The Contract May Be Subject To Modification If, In The Course Of Performing The Works, It Turns Out That The Design Documentation Contains Defects That Could Not Be Identified Before Concluding The Contract And The Existence Of Which Makes It Impossible To Perform The Works In Accordance With Applicable Regulations And Standards. In Such A Case, With The Participation Of The Designer And The Supervision Inspector, The Parties Determine The Scope Of Abandoned And Additional Works And The Scope Of Replacement Works, And The Modified Method Of Performance Will Be Determine