Tenders Are Invited For Obtaining Energy Autonomy Of Public Utility Facilities With The Possibility Of Temporary Accommodation Of People And Staff Of The Third Party Liability Insurance And The Polish Armed Forces

1. The Order Includes The Purchase, Assembly And Commissioning Of A 48Kw 60 Kva Generator And Preparation Of The Generator Room (Replacement Of Doors, Installation Of Foundation Strips, Construction Of A Thick-Layer Floor For Medium Loads, Ventilation Grilles, Exhaust Gas Discharge, Internal Plastering And Painting)2. The Supplied Device Is Intended To Provide Backup Power Supply. 3. The Offered Device Must Be Brand New, Unused, Complete, Assembled, Ready For Use In Accordance With Its Intended Purpose, Free From Physical And Legal Defects, In Accordance With Relevant Standards And Legal Regulations, In Particular Regarding Their Admission To Trading And Use. The Ordering Party Does Not Allow Prototype Products And Equipment Manufactured Before 2025. The Scope Of Work Includes, Among Others: 1. 40Kw Generator - Replacement Of Switchboards With An Area Of ​​Over 0.5 M2, Zk To Ps-Rs, Change Of Location Of The Measurement System - Ats System For A 40Kw Generator - 48Kw 60Kva Generator - Installation Of Three-Phase Diesel-Electric Generators With A Power Of Up To 55Kw2. Cable Line For The Generator - Manual Dismantling Of Pavement Surfaces Made Of 6 Cm Thick Mineral-Bituminous Masses - Manual Digging Of Cable Trenches In Category Iii Soil (35X0.8X0.4) - Laying Cables Weighing Up To 2.0 Kg/M In Cable Trenches Manually Yakxs 4X25mm2 - Laying Cables Weighing Up To 0.5 Kg/M In Cable Ditches Manually (Control Cables) - Backfilling Of Ditches For Cables Made Manually In The Ground, Category Iii - Surfaces After Cable Works On Sidewalks, Entrances, Squares Made Of 6 Cm Thick Concrete Paving Stones On Sand Ballast - 3. Generator Room - Replacement Of Door And Window Frame Elements Embedded In The Wall - Replacement Of Double-Leaf Doors With A Width Of 1.6 M - Foundation Footings Reinforced Concrete Up To 1.3 M Wide - Installation Of Reinforcement For Footings And Foundation Footings, Beams, Beams, Tie Beams, Walls, Individually And Cross-Reinforced Slabs - Rods With A Diameter Of 28-32 Mm - Thick-Layer Floor For Medium Loads - Ventilation Grilles Type A Or N With A Circumference Of Up To 1400 Mm - For Steel And Aluminum Ducts - Heat Pipelines Made Of Steel Pipes With A Diameter Of Up To 150 Mm - Internal Plaster With An Area Of ​​Over 5 M2 Made Of Lime Or Cem-Lime Mortar. Category Iii/Iv, Manual Execution On Beams, Columns, Joists, Flights And Landings Of Staircases - Painting Of Internal Plasters With Adhesive Paint, Priming4. Measurements - Measurement Of Insulation Resistance And Electrical Installation - 3-Phase Circuit - Tests And Measurements Of The Earthing Installation - Checking And Measurement Of 3-Phase Low Voltage Electrical Circuit5. Project + Instructions For Cooperation With Energa Operator - Electrical Design - Instructions For Cooperation With Energa Operator 6. The Detailed Scope And Type Of Work To Be Performed As Part Of The Subject Of The Order Is Presented In: A) Bill Of Quantities And Offer Cost Estimate