Tenders Are Invited For Modernization Of The Orlik 2012 Sports Complex In Izdebki

The Subject Of The Order Is The Renovation Of Sports Surfaces In The Orlik 2012 Sports Complex Located In Izdebki, Plot No. 5771. The Investment Plan Includes: A. General Works: Repair Of Entrance Gates To Orlik - 2 Pieces; Disposal Of Old Grass And Sbr Granules; Repair Of Paving Stones And Its Partial Replacement On Roads And Access Squares To And Near Orlik; Improvement Of The Damaged Fence Of Orlik;B. Works On The Football Pitch: Machine Removal Of The Old Synthetic Surface On The Football Pitch (Minimum Sampling Width 150 Cm); Leveling Of The Entire Sub-Base Slab To Reach An Elevation Of 334.2 M Above Sea Level; Spreading Stone Dust With A Fraction Of 0.075 - 4 Mm On The Entire Pitch Slab - A Layer Of 1 Cm After Compaction. Leveling The Pitch; Hardening The Slab To Is>0.97;  Laying Woven Synthetic Grass With Minimum Parameters: • Synthetic Grass Made Using The Woven Or Tufted Method, With A Blade Height Of Min. 45 Mm, Meeting The Requirements Of Fifa Quality Concept For Football Turf (Manual 2015),• Filling: Recycled Epdm,• Dtex Of The Bunch – Min. 13,000, Fiber/Monofilament Thickness – Min. 330 Μm. In The Case Of Systems Using More Than One Type Of Fiber, The Thickness Requirement Applies To Each Type Of Fiber Used In The Offered Paving System;• Number Of Tufts - Min. 6,000/M2, • Fleece Weight – Min. 1,600 G/M2, • Bunch Pulling Force - Min. 40 N,• Strength Of Glued Joints After Aging – Min. 95 N/100Mm,• Water Permeability In The Grass: Minimum 1600 Mm/H,• Type Of Fiber: Polyethylene, Monofilament - No Requirement For At Least Three Different Types Of Fiber Cross-Sections To Be Present In One Bundle,• Base: Polyolefin, Latex Or Polyurethane,• The Use Of A Layer Of Latex Using Butadiene And Polyurethane Is Not Allowed,• Surface Color: Green In Minimum Of Two Different Shades, • Football Lines Pasted Into The Surface. Pasting Lines Marking The Pitch In Accordance With The Requirements Of The Polish Football Association;  Backfilling The Pitch With Quartz And Epdm Granules In Accordance With The Manufacturers Requirements;  Replacement Of Football Goals And Nets With New Ones;  Repair Of Ball Catchers With Replacement Of Lines And Nets, As Well As Stabilization Of Load-Bearing Poles And Replacement Of Upper Crossbars In Ball Catchers; C. Works On The Multi-Purpose Pitch: Removal Of The Top Layer Of The Pu Surface On The Multi-Purpose Pitch By Milling; Priming Of The Pu Surface; Laying A New Polyurethane Surface, Permeable To Water And Intended For Outdoor Multi-Purpose Pitches. The Surface Can Be Made As A Type 2S Surface Or A Spray Coat, While Maintaining All The Minimum Requirements Specified Below. • In The Case Of Type 2S Surfaces:  The Lower Layer Should Be Made Of A Mixture Of Sbr Rubber Granules With A Granulation Of 1-4 Mm, Connected With A Polyurethane Binder;  The Lower Layer Laid Mechanically, Jointlessly, Using A Mass Spreader Polyurethane; The Upper Layer Should Be Made Of Epdm Granules With A Granulation Of 1-3 Mm, Conne