Request For Quotation Differential Pressure Sensor

Differential Intelligent Differential Pressure Sensor (With Three-Valve Block) - 1 Set. General Industrial Differential Pressure Transmitters In A Field Housing With A Stainless Steel Measuring Membrane And A Metal Cable Entry. Technical Specification: • Measuring The Pressure Difference Of Media Neutral To Stainless Steel (Air, Steam, Various Liquids), • Conversion Of Differential Pressure Into A Unified Dc Signal 4...20 Ma And Hart Protocol, • Lower Limit Of The Measured Pressure Difference (Lpi) – A Series Of Variable Values From 0 Kpa; • Upper Limit Of The Measured Pressure Difference (Urp) – A Range Of Variable Values ​​Up To 40 Kpa; • Maximum Static Pressure – 10 Mpa; • Accuracy Class – 0.1% (0.5% Allowed), • The Presence Of A Hart Interface For Transmitting Information In Digital Form About The Measured Parameters And The State Of The Device, • Built-In Linearly Decreasing And Root-Extracting Functions Of The Output Signal, • The Ability To Reconfigure The Converter From The Buttons On The Front Panel, • Built-In Front Panel, With Backlit Liquid Crystal Display, Displaying: Value / Units / % Of Measured Pressure + Graphic Scale, • Range Reconfiguration Up To 100:1, • The Housing Rotates 360° Relative To The Measuring Fitting, The Indicator Rotates 330°., • Degree Of Protection Of The Pressure Sensor Housing – Ip65, • Noise Immunity Meets The Requirements For Class A Equipment According To Gost R 51522, • Overload Capacity – Not Less Than 800% Of Full Load Capacity. The Most Suitable Sensors For This Technical Specification: Aries Pd200-Dd0.04-155-0.25-2-N, Or Elemer Air20/M2-N-Dd 440 40 Kpa. Each Sensor Kit Must Include Three-Valve (Or Five-Valve) Blocks For Connecting The Sensor To Impulse Lines.