Tenders Are Invited For Specialist Vehicles – Construction And Delivery Of 2 Grooved Rail Cleaning Vehicles Based On A Motor Vehicle

Specialist Vehicles – Construction And Delivery Of 2 Grooved Rail Cleaning Vehicles Based On A Motor Vehicle. Construction And Delivery Of 2 Grooved Rail Cleaning Vehicles Based On A Two-Way Vehicle, Which Is Used For Cleaning Rails, Rail Grooves, Switch Boxes And Rail Drainage Systems. It Must Be Possible To Use The Vehicles Both On The Road And On Rails Throughout Dvb Ags Route Network, Including Under Low Structures (Under Bridges With A Contact Wire Height Of 4.05 M Above Sok), Tight Curves And Narrow Streets. Basic Two-Axle Chassis: - Wheelbase: Approx. 4,200 Mm; - Vehicle Or Track Width Based On The Outer Wheel Edges: Max. 2,300 Mm; - Vehicle Length: Max. 6,500 Mm; - Vehicle Height: 3,200 Mm, When On The Rails Max. 3,700 Mm; - Permissible Total Weight: Approx. 14 T. Cleaning/Suction Device: - Suction Power At Least 12,000 M²/H; - Dirt Container Volume: At Least 4 M²; - Fresh Water Supply With At Least 1.25 M² Rail Guide/Rail Travel Device: - Track Width: 1,450 Mm; - Smallest Curve Radius That Can Be Traveled On: 17 M (Must Be Able To Be Navigated Forwards And Backwards); - Ground Clearance With Raised Sfe At Least 160 Mm; - Accessibility Of Mountain And Downhill Stretches: Max. Gradient Of 8.1% (Must Be Passable In Both Directions Without Restrictions) Compliance With The Regulations Valid In The Ec Economic Area, Recognized Safety Regulations And Stvo/Stvzo, Accident Prevention Regulations Bg, Approval Certificate Part 2 Or Individual Approval According To § 13 Eg-Fgv Including Any Necessary Special Permits, Stability And Braking Calculations According To Bo Strab, Proof Of Derailment Safety, Dynamic Envelope Curves Of The Entire Vehicle For Acceptance By The Tab.