Luminaire For Led Public Lighting, Color Temperature Of 5000K (+312K - 254K), Irc 70, Power Factor 0.98, Minimum Luminous Flux Of 15000 Lumens, Minimum Efficiency Of 150 Lm/W, Maximum System Power 100W, Lesser Harmonic Distortion Equal To 10%. Service Life 90,000 Hours, Minimum Degree Of Protection Of The Housing And Optical Body Assembly Ip-66 And Impact Protection Ik 08. Operating Temperature From -10°C To 40°C. Voltage 90 To 305 Vac. Body Produced In Aluminum Alloy Injected At High Pressure Sae 306, (Lights Made Of Aluminum Plates, Extruded Aluminum Or Any Other Material Other Than High Pressure Injection Are Not Permitted), With Housing For Mounting The Driver, No Communication (Same Environment) With The Optical Body After Closing The Part, High Electrical And Photometric Efficiency. Lens For High Performance Photometric Distribution, Material In Pmma, Allowing Excellent Luminotechnical Indices With Classification Of Luminous Intensity Distributions According To Abnt Nbr 5101, Transverse Distribution Type Ii, Average Longitudinal Distribution And Limited Or Totally Limited Luminous Intensity Distribution Control. Be Accompanied By A Photoelectric Relay As An Operating System That Turns On And Off Depending On The Variation In The Luminous Flux, Alternating Current Electromagnetic Construction System, Type Nf, With Tin Brass Contact Pin, Attached To The Body Of The Riveting System, Cds Type Cell With Armored Casing For Instant Response, 1000 W, 1800 Va. - Refractor Must Be Made Of Smooth, Transparent, Tempered, Flat Glass, Resistant To Thermal Shocks, And Must Not Present Imperfections, Manufacturing Flaws Or Bubbles. Ip-66), ..., Minimum Luminous Flux Of 27000 Lumens, Maximum System Power 180W, Average Longitudinal Distribution And Limited Or Totally Limited Luminous Intensity Distribution Control. It Must Have Mechanical Resistance To Impact Ik 08. - Housing With Degree Of Protection Ip-66, Made Of High Pressure Injected Aluminum Alloy Sae 306 Alloy, With High Engraving..., Perforating Connector Cdp 70, Pre-Insulated Sleeves For 2.5 Mm Cables, Galvanized Screw 16 X 250 Mm With Double Thread And 4 Nuts And 2 Washers., Galvanized Screw 16 X 300 Mm With Double Thread And 4 Nuts And 2 Washers., Galvanized Screw 16 Galvanized Screw 16 Insulated Conductors And Cables, Nbr 6245 - Determination Of The Oxygen Index, Nbr Nm 60332-3-24 - Vertical Burning - Bonfire, Nbr 5111 - Bare Copper Wires Of Circular Section For Electrical Purposes - Specification And Nbr 13249 - Flexible Cables And Cords For Voltages Up To 750V., Arm Br-2, 1, 80
