Bids Are Invited For Acquisition Of Furniture To Equip The Elderly Community Center In Morada Da Barra.

Steel File Cabinet With 04 (Four) Drawers Dimensions: 1335 X 470 X 600 Mm. Internal Measurements In Drawers: 280 X 390 X 590Mm (H X W X D). All Steel Filing Cabinet With Non-Removable External Box And Built-In Drawers Around The Entire Perimeter. Body, Drawers And Top Plate 22 (0.75 Mm), Laminated Carbon Steel Ff.Rb.Ol 1008/1010. Drawers With Support For Hanging Folders In The Shape Of A “U” Welded On The Front And Back Of Each Side To Accommodate Hanging Folders. Progressive Telescopic Carts Equipped With 8 1 Zinc-Plated Steel Castors, Yale-Type Chrome-Plated Lock With 4 Safety Pins And 2 Keys. L-Shaped Polypropylene Shoes With Height Adjustment Using A Pin With A ¼ Metal Thread Fitted To The 4 Corners Of The Cabinet To Correct Small Unevenness And Avoid Direct Contact Between The Plate And The Floor, Steel Cabinet With 2 (Two) Opening Doors Dimensions: 1970 X 1200 X 450 Mm (H Internal Reinforcement Omega On Each Door, Fixed Using Spot Welding, Structure, Doors, Body Plate 22 (0.75 Mm). Top And Bottom. Each Side Of The Cabinet, On The Inside, Must Contain Two Straight Vertical Racks, In Parallel, Fixed Using Spot Welding On 24 Sheet Metal, At Intervals Of 50 Mm. (Sixteen) Overlapping Doors Dimensions: 1970 X 1250 X 450 Mm (H Recessed. Made From Sheet Metal 22 (0.75 Mm). Closing Handle With A Padlock Containing An Oblong Hole Of 12X8 Mm, With One Piece Dotted On The Central Left Side Of The Door And Another On The Side Body Of The Wardrobe. 80 Mm. Printed On The Upper And Lower Part Of The Right Side Of The Doors, Without External Protrusion, With The High Relief Facing The Internal Side Of The Compartment. Door Label Printed On The Upper Left Side Of Each Door, For User Identification. (Lower Work Area And Upper User Access Area), In 25 Mm Thick Mdp Covered In Textured Low-Pressure Melamine Laminate On Both Sides, Edge That Follows The Entire Contour Of The Top With A Thickness Of 2.5 Mm, Hot Glued Using The Holt-Melt System, With A Minimum Radius Of 2.5 Mm. 18 Mm Thick Mdp, Covered In Textured Low-Pressure Melamine Laminate On Both Sides. Horizontal Edges With 2 Mm Finish Hot-Glued Using The Holt-Melt System. 1.5Mm Thick With Paint Finish. Top Sides In 25Mm Thick Mdp