Tenders Are Invited For Sewage Presses – Delivery And Installation Of A Baling Press For Pressing Waste And Recyclable Raw Materials

Sewage Presses – Delivery And Installation Of A Baling Press For Pressing Waste And Recyclable Raw Materials. The Contractor Will Deliver To The Ordering Partys Headquarters At Ul. Mazurska 42 In Elbląg And Will Install A Baling (Channel) Press In Accordance With The Requirements Below. 1. The Contractor Will Deliver And Assemble The Press In The Place Indicated By The Ordering Party. The Required Press Equipment Will Be The Conveyor Described In Point 2 2. The Contractor Will Design And Deliver A New Conveyor. The Delivered Conveyor Will Supply The New Baler With Goods To Be Pressed. The Conveyor Must Consist Of One Rising Belt And A Ground-Level Feed Hopper And A Discharge Into The Press Hopper. The Conveyor Must Be Included In The Power Supply, Security And Press Control System (Its Status Must Be Visible On The Operator Panel). The Ordering Party Intends To Include The Delivered Press In The Technological Line Of The Newly Built Sorting Plant, Therefore The Conveyor Must Be Easily Detachable From The Press. 3. The Press Must Be Horizontal (The Piston Works Horizontally), Intended For Baling Raw Material Waste Sorted From Mixed And Selectively Collected Waste. The Ordering Party Does Not Allow The Delivery Of A Baling Press In A Prototype Version. 4. The Press Must Be Brand New, Manufactured No Earlier Than 2026, Unused, Complete, Undamaged. The Table Below Describes The Important Parameters That The Delivered Press Must Have.