Tenders Are Invited For Modernization Of Municipal Roads

I. Subject Matter Of The Order. The Subject Of The Order Is: Modernization Of Municipal Roads, Including: Section 1. Municipal Road Kłodnia - Kwieki - 300 M. Section 2. Municipal Road To The Town Of Lutom - 300 M. Section 3. Kurcze - Bagna Road - Section 1 - 200 Mb. Episode 4. Road Kurcze - Bagna - Episode 2 - 60 M. Section 5. Klaskawa - Szlachta - 40 M. Section 6. Road In The Town Of Kwieki - 110 M. Ii. Other Information For The Contractor.1. Before Starting The Works, The Contractor Will Develop A Traffic Organization Plan For The Duration Of The Works, Which Will Be Approved By The Relevant Authorities And Road Managers.2. The Contractor Is Obliged To Demarcate The Boundaries Of The Road In Detail - The Above-Mentioned. Plots. The Staking Sketch Will Constitute An Integral Part Of The Acceptance Documentation.3. Before Starting The Work, The Contractor Will Agree With Zuk Sp. Z O. O. In Czersk, Location Of Wells And Valves Of The Water And Sewage Network. And Will Adjust The Height In Relation To The Future Road Surface, And After Completing The Work, It Will Present The Ordering Party With A Report Written With A Representative Of Zuk Czersk Confirming The Correct Execution Of This Adjustment. 4. The Contractor Is Responsible For Tidying Up, Compacting And Strengthening The Sides Of The Road Section In Question (Using A Gravel And Clay Mixture Purchased By The Contractor). Sides 2X 75 Cm Wide With A Slope Of 6% To 8% Outside (Assuming They Can Be Constructed Due To The Border Of The Road).5. The Subject Of The Order Was Specified In Detail In The Technical Specification For The Execution And Acceptance Of The Works And, Additionally, In The Bill Of Quantities Constituting Annexes To The Swz.6. The Contractor Is Obliged To Purchase And Set Up 3 Information Boards Regarding Investment Co-Financing From The State Forests, Along With A Frame (3 Pieces) According To The Pattern Specified In Annex No. 7 To The Description Of The Subject Of The Order.7. If In The Description Of The Subject Of The Order, Design Documentation, Technical Specifications For The Execution And Acceptance Of Works, Bills Of Quantities, Explanations For The Tender, The Ordering Party Indicates The Names Of Manufacturers Of Materials, Devices, Products, Etc., This Means That The Contractor May Adopt The Solutions Indicated By The Ordering Party Or Equivalent. However, The Contractor Must Demonstrate That The Materials, Devices, Etc. Used Are Equivalent. The Ordering Party Describes The Subject Of The Contract By Reference To Standards, Technical Assessments, Technical Specifications And Technical Reference Systems Referred To In Art. 101 Section 1 Point 2 And Section 3 Of The Public Procurement Law Allows Solutions Equivalent To Those Described, And Such A Reference Is Accompanied By The Words Or Equivalent.8. All Terms And Names Of Materials Are Only Used To Determine The Quality Parameters Of The Materials Used. The Failure Of The Ordering Party To Specify Specific Require