Bids Are Invited For Acquisition Of School Furniture

Abs Childrens Student Set: Student Set Consisting Of A Table And A Chair, Which Must Be Certified In Accordance With The Compulsory Standard Abnt Nbr 14006. Table: The Table Must Have A Height Of 590 Mm And Allow Complete Assembly Through Fittings Of Its Components, And Can Be Used On Both Sides, Front Or Back, Depending On The Users Choice. The Top Must Be Injected Into Virgin Abs Thermoplastic With Pigmentation, With A Smooth And Shine-Free Surface, In A Rectangular Shape. It Must Be Fixed To The Counter Top Using A Fitting Along Its Entire Side And Four Screw Fixing Towers. The Counter Top Must Support, Reinforce And Structure The Surface Of The Top, In Addition To Providing A Finish On Its Lower Part. The Approximate Dimensions Of The Top Must Be 620 Mm (Width) X 485 Mm (Depth), Containing A Rectangular Storage Compartment On Its Back. The Table Must Have A Book Holder In A Rectangular Shape, Injected In Thermoplastic With A Textured Surface. Components, , Abs Adult Student Set: Student Set Formed By A Table And A Chair, Which Must Be Certified According To The Compulsory Standard Abnt Nbr 14006. Table: The Table Must Have A Height Of 760 Mm And Allow Complete Assembly By Means Of Fittings Of Its Components, Teacher Set: Set Of Table And Fixed Chair For Teacher. Table: It Must Have A Top Injected In Thermoplastic Based On Natural Abs With Pigmentation, A Smooth Surface, Without Shine And With A Rectangular Shape. This Top Must Be Fixed To The Structure Using Fittings, With Four Fittings On The Sides Of The Table (Two On Each Side), In Addition To Three Central Fittings And Four Screws. The Table Must Have A White Front Panel Measuring 650 Mm X 250 Mm, Made Of Low Pressure Melamine Laminate, 15 Mm Thick, Which Must Be Fixed To The Front Of The Structure Using Screws. After Assembled, The Table Should Measure Approximately 820 Mm (Length) X 620 Mm (Width) And Should Be 760 Mm High. The Structure Must Be Formed By A Frame Made Of Steel Tube Composed Of Three Beams And Two Headboards. In Each Corner Of The Board, There Must Be A Steel Cone At The Bottom For Mounting The Fixed Table Legs. O Co, 04/16/2026 - 15:49:21