Electrical Fitting Work – Renovation Of The Former St. Michael Monastery Complex - Electrical Work On The Toilet System. Operating Voltage: 3X 400 / 230V 50Hz. Protective Measures: Triggered By Overcurrent Protection Devices, Protective Conductor From Distribution Or Sub-Distribution; Fi Protection Circuit, If=0.03A. Connection: The Connection Is To The Bamberg Municipal Utility Network Area. . Distributions: All Distributions Must Comply With Applicable Regulations. Type Test Certificates From The Manufacturer Must Be Presented At The Clients Request; Routine Test Reports Must Always Be Enclosed With The Inventory Documents. All Built-In Devices In A Distribution Such As B. Circuit Breakers, Relays, Etc. Must Only Be Installed By One Manufacturer! The Distributors Must Generally Be Equipped With At Least 30% Space Reserve For Subsequent Installation. The Circuit Breakers Must Be Mounted Flexibly And Without Pulling On Top-Hat Rails In Accordance With Applicable Standards. In The Installed Position, The Busbar Of The Busbar (Comb Rail) Is Located Behind The Terminal, So That Devices Can Be Easily Replaced At Any Time. Effective Protection Against Contact, Even When Reaching Around, Must Be Guaranteed. Labeling On The Cables, Terminals And On The Fuse Replacement After The Distributor Panels Is Required. The Distributions Must Be Covered With Marshalling Tape For The Cable Entries, I.E. H. Design The Cover Profile And End Caps As Snap-In Connectors. The Circuit Assignment And Terminals Must Be Numbered Identically. A Plan Pocket With 1 Set Of Circuit Diagrams For The Respective Distribution Must Be Permanently Attached To The Door. The Basic Circuit Diagrams Must Be Provided With The Terminal Designations. All Circuits Must Be Run On Terminal Blocks; These Must Be Included In The Unit Prices. Riser Lines: The Riser Lines Are Laid In Accordance With Utility Regulations With Appropriate Cross-Sections And The Control Lines To The Sub-Distributors Specified By The Utility Company. The Arrangement And Routing Of The Risers Can Be Found In The Respective Schematic Diagrams. The Basic Circuit Diagram Can Be Viewed By The Designer. . Installation: Cable Laying Is Always Horizontal And Vertical. Installation Heights For Flush-Mounted Installation: Switches And Buttons Below 1.05 M Above Okff. Sockets Etc. 0.30 M Above Okff. Sockets Above Work Surfaces Etc. 1.05 M Above Okff. Mirror Lights 1.85 M Above Okff. Junction Boxes 0.30 M Below Ukfd. Socket Locations For Extractor Hoods Can Be Found In The Kitchen Installation Plan. Installation Heights Fr-Ap Installation: Switches And Sockets (On Site) 1.05 M Above Okff. Switches And Sockets On Tiled Walls Must Be Installed Exactly In The Joint Space (Collaboration With The Tiler, Including Marking, Etc. This Additional Work Must Be Included In The Unit Prices). When Installing Rocker Switches, Ensure That The Switch Position Is The Same. Light And Socket Circuits Must Be Laid Separately. Fire-Retardant Cavity Wall Boxes Must Be Used For Switch And Junction Boxes In Lightweight Walls. It Is A Low Junction Box Installation
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
