Tenders Are Invited For Engineering Design Services – Sv-Cmü-260319-001 - Tw - Replacement New Building Bad Forstenrieder Park, Fachpl Technical Equipment, Ag 4.5&6

Engineering Design Services – Sv-Cmü-260319-001 - Tw - Replacement New Building Bad Forstenrieder Park, Fachpl Technical Equipment, Ag 4.5&6. Planning Services In Accordance With Hoai 2021 In Service Phases 1 - 9 For The Specialist Planning Of Technical Equipment (System Groups 4, 5 And 6) With Step-By-Step Commissioning For The Replacement Construction Project For Bad Forstenrieder Park. A New Indoor Swimming Pool With An Expanded Range Of Uses And An Expected Gross Floor Area Of ​​Around 9,156 M² Is To Be Built On The Site Of The Former Forstenrieder Park Swimming Pool. The Scope Of The Project Is The Construction Of A New Replacement Building With The Following Scope: 25 M Sports Pool With 50 M Pool Extension, A Movable Partition And 1 M Diving Board, Teaching Pool With Lifting Floor And Ninja Course, Childrens Paddling Area Inside And Outside With Spray Park, Outdoor Pool With Swim-Out Channel And Cover, Adventure Slide 70 M With Access Without A Flat Rate Increase In The Swimming Pool, Sauna Area Inside And Outside, Photovoltaics On The Roof Areas, Restoration And Revision Of The Open Spaces With Lawns, Bicycle And Car Parking Spaces. The Planning Of The Luminaires In Areas With Public Traffic Is Carried Out In Phases 1-5 By A Separately Commissioned Lighting Planning Specialist. However, Since The Installation Of All Lights Is To Be Carried Out By The Electrical Trade, The Contractors Participation In This Service Is Required. From Service Phase 6 Onwards, The Contractor Is Responsible For Planning And Costs With The Involvement Of The Lighting Planner. The Mains Transformer Station Located On The Property Is Expected To Be Replaced By A Mains Transformer Station With A Higher Connected Load, As This Will Probably Not Be Sufficient For The Energy Requirements Of The New Indoor Swimming Pool. Project-Specific Requirement: Bim Method (Use Of Industry-Standard Documents Such As Aia And Bap, Use Of A Bim-Capable Project Platform And Application Of A Collaborative Working Method) With The Aim Of: As-Built Model.