Tenders Are Invited For Development Of Technical Documentation For A Garage And Social Building - Material Base In Leżajsk

The Subject Of The Order Is The Development Of Technical Documentation For A Garage And Social Building In The Material Base In Leżajsk In The Following Stages: • Stage I: Design Concept (Presentation Of Initial Functional, Spatial, Material And Technical Solutions). Preparation And Obtaining Written Acceptance Of The Ordering Party. The Deadline For Submitting And Accepting The Concept Is Specified In Point Iii.1. Opz.• Stage Ii: Construction Design (Pb), Technical Design (Pt), Executive Design (Pw) Of All Industries And Land Development Design (Pzt). Development Of Appropriate Documentation Based On The Approved Concept. The Order Should Include The Development Of Documentation For The Garage And Social Building, Including Land Development And Hardening Of The Square While Maintaining A Minimum Biologically Active Surface, Design Of Access Roads And Parking Spaces, Design Of Network Connections And Installations (Energy, Gas, Sanitary And Rainwater Sewage, Water Supply, Telecommunications, Ventilation, Lightning Protection And Monitoring Of The Building And Square), Etc. Characteristics Of The Project Investment:1. The Garage And Social Building Should Be Designed As A Single-Block Brick Structure With No Basement, One-Story With Usable Space Above The Social Part And A Two-Car Detached Garage With Dimensions Of Approximately 1200X1800 (Including The Social Part With Dimensions Of Approximately 1200X700).2. The Office And Social Part Should Have At Least The Following Rooms: Social Room, Cloakroom, Office Room, Corridor, Toilet, Boiler Room, Entrance To The Attic (It Is Planned To Create An Open Space Above The Ground Floor, I.E. A Utility Room Separated From The Garage Part By A Brick Wall).3. Garage Part Of The Building Intended For Servicing And Storing Road Equipment And Trucks.4. Building Structure On Strip Foundations (Selection Of Solution Based On Geotechnical Documentation), Stability And Load-Bearing Capacity Under Operational Loads From Vehicles And Equipment. 5. Window And Door Joinery Adapted To The Function Of The Facility.6. Horizontal And Vertical Insulation Of Reinforced Concrete Elements With Two Layers Of Asphalt Emulsion.7. Gable Roof Structure, Covered With Sheet Metal.8. Ceiling Made Of Reinforced Concrete Slab Above The Social And Office Area.9. Surface Drainage Of A Gable Roof Truss With Roof Gutters And Steel Downpipes.10. Internal Floor Layer In The Garage: Industrial Concrete Adapted To The Loads Of Vehicles And Equipment, Resistant To Oils And Fuels. 11. Sectional Gates With Mechanical, Manual And Electric Drive Operated By An Electronic Remote Control (With Entry And Lighting Function).12. In Order To Protect And Secure The Structural Elements And Edges Of The Walls Of The Garage Part, The So-Called Fenders.13. Designing Video Monitoring Cameras Covering The Square And Entrance With A Recorder And An Electronic Alarm System Of The Building Itself.14. Internal Single-Phase And Three-Phase Electrical Installation With