Bids Are Invited For Rsd-020116/005115/2025 - Acquisition Of Heat Exchangers (Heaters) And A Motor Pump For The Swimming Pool Of The Future Annex Of The Engenheiro Passos Rehabilitation Center, Through The Municipal Health Department - Fms.

Heat Exchanger For Swimming Poolheat Exchanger For Swimming Pool (Heater). Thermal Capacity Of 30,000 Btu/H Application: Swimming Pool Heating Type: Shell And Tube Heat Exchanger (Or Plates, Depending On The Manufacturer) Manufacturing Material: Body In Stainless Steel 304/316 Or Titanium (High Resistance To Corrosion); Internal Piping In Copper Or Titanium (Compatible With Chlorinated Water And Treated With Salt). Recommended Pool Water Flow: 4 To 6 M3/H Recommended Hot Water Flow (Boiler/Heater/Solar): 1 To 2 M3/H Hydraulic Load Loss: Low (Up To 1 M.C.A) Maximum Operating Temperature: Up To 90 Degrees Celsius In The Hot Water Circuit. Maximum Working Pressure: 8 Bar (Hot Water Side) And 4 Bar (Pool Side). Hydraulic Connections: Threaded Or Flanged Inlet And Outlet. Thermal Exchange Efficiency: Greater Than Or Equal To 90% Installation: Can Be Connected To A Solar, Gas, Electric Or Heat Pump Heating System. Inmetro Certification Manufacturer Warranty., Motor Pump For Swimming Pool Motor Pump For Swimming Pool. Power: 1.0 Hp (735 W); Voltage: 110/220 V (Single Phase) - 60 Hz; Rotation: ~3,500 Rpm; Nominal Current: ~7-8 A (110 V) / 3.5-4 A (220 V); Flow Rate: 10 To 17 M3/H; Gauge Height: 9 To 18 Mca. Materials: Reinforced Thermoplastic Body; Stainless Steel Shaft And Noryl Rotor. Water Temperature Up To 50 Degrees Celsius. Thermal Protector, Ip55 (Shielded Motor). Weight: 10 To 20 Kg. Inmetro Certification. Warranty Offered By The Manufacturer.