Tenders Are Invited For Partial Renovations Of Road Surfaces

Partial Renovations On District Roads In The Nysa District: 1. Battens Up To 5 M2 - 1,400.00 M2.2. Battens From 5 M2 To 50 M2 - 1,500.00 M2.3. Battens Over 50 M2 - 2,000.00 M2.4. Surface Milling - 250.00 M2.5. Removal Of Rubble From The Demolition Site With Mechanical Loading And Manual Unloading By Truck - 10.00 M3. Construction Of Bituminous Overlays Along The Entire Width Of The Road In Locations According To The Employers Instructions. Section Length: Minimum 50.0 M:1. Milling Of Bituminous Surface With A Thickness Of Up To 4 Cm With Removal Of Demolition Material Up To 1 Km Away - 156.00 M22. Sprinkling The Road Surface With Asphalt – 1,000.00 M23. Surface Made Of Mineral-Bituminous Chipping Mixtures - Asphalt Wearing Course - Thickness After Compaction 4 Cm - 1000.00 M2. Preparation Of The Damaged Area (Defect, Pothole Or Broken Edges Of The Surface) For Repair Should Be Done Very Carefully By: 1. Demolition Of Damaged Surface Using A Milling Machine,2. Vertical Cutting (Preferably With Diamond Circular Saws) Of The Edges Of The Damage To A Depth Enabling Leveling Of Its Bottom, Giving The Damage The Shape Of A Simple Geometric Figure, E.G. A Rectangle.3. Thorough Cleaning Of The Bottom And Edges Of The Damaged Area From Loose Grit Grains, Gravel, Sand And Dust And Removal Of Residual Water, Bringing The Damaged Area To An Air-Dry State. 2) The Scope And Location Of The Works Will Be Determined By The Ordering Party. 3) The Ordering Party Will Provide The Instructions For Carrying Out The Works. 4) The Implementation Of Works Depends On Weather Conditions. The Detailed Scope Of Works Includes: 1) Bill Of Quantities, 2) Technical Specification, Execution And Acceptance Of Construction Works In The Construction Parts, Including Requirements Regarding The Properties Of Materials, Requirements Regarding The Method Of Execution And Assessment Of The Correctness Of Execution Of Individual Works. As Part Of The Order, The Contractor Is Also Obliged To: 1) Comply With Occupational Health And Safety Regulations, 2) Make And Maintain Signage During The Works, (The Ordering Party Will Provide The Contractor With An Approved Temporary Traffic Organization Design, And The Contractor Will Report It To The Relevant Authorities To Change The Traffic Organization For The Duration Of The Works), 3) The Contractor, As The Producer Of Waste Generated During The Works, Is Responsible For Its Storage And, If Necessary, Should Regulate The Formal And Legal Status In The Field Of Waste Management (Act Of 14/12/2012 On Waste, Journal Of Laws Of 2020, Item 2361, As Amended),