Motor Oil 15W-40 For Gasoline Engines, Technical Characteristics Of The Quality Of Industrial Oil I-40. Compliance With The Requirements: 1) Kinematic Viscosity At 40°C Mm S/S 65.8 2) Viscosity Index Gost 25371 No Less Than 90 3) Density At 20 °C Kg/M3 Gost 3900 No More Than 882 4) Acid Number, Mg Conn 1G. Oils Gost 3900 No More Than 880 5) Ash Content % Gost 1481 No More Than 0.2 6) Flash Point °C Gost 4333 No Less Than 236 7) Pour Point °C No Higher Than – 15 8) Mass Fraction Of Mechanical Impurities No 9) Mass Fraction Of Water % Mass Gost 2477 No 10) Content Of Selective Solvents No More Than 0.5 11) Temperature Self-Ignition °C 362 Products Are Delivered According To Schedule: Until April 1 - 1500 Liters; September -1500 Liters. Total: 3000 Liters. (Packaging In Containers From 5 To 50 Liters), Diesel Engine Fluid Scr Nor Blue Aus 30, Produced In Accordance With The Iso 22241 Euro-6 Standard, Consists Of A Solution Of Water And Urea: Demineralized Water - 67.5% Solution; Urea – 32.5% Solution. Required Documentation: 1) Passport And Instruction Manual; 2) Certificates Of Conformity., Motor Oil For Automobile And Tractor Diesel Engines M-10Dm, Intended For Summer Operation Of Highly Accelerated Turbocharged Diesel Engines Of Main-Line Tractors, Timber Trucks, Heavy-Duty Dump Trucks, Industrial Tractors Of Domestic And Foreign Production Operating In Difficult Conditions. Can Be Used In Naturally Aspirated Diesel Engines With Significantly Increased Mileage Between Oil Changes. It Is Made From Mineral Base Oils With The Addition Of An Effective Additive Composition. Name Of Indicator Norm Kinematic Viscosity At 1000C, Mm2/S 15.4 Viscosity Index 93 Flash Point In An Open Crucible, 0C 246 Pour Point, 0C -21 Base Number, Mg Koh/G 9.0 Sulfate Ash, % 1.3 Density, At 20 0C, G/Cm3 0.897 Container 5 Liters, Hydraulic Oil Mge-46V Operates At Pressures Up To 35 Mpa With A Short-Term Increase To 42 Mpa. Operable In Hydrostatic Transmission Units In The Temperature Range From -10 To +80 Degrees Celsius. Kinematic Viscosity Gost 33 At 100 Degrees - 6.7, At 40 Degrees - 46.4. Viscosity Index - 95 Gost 25371. Flash Point Gost 4333 In An Open Crucible - 231 Degrees Celsius. Pour Point - (-33) Degrees Celsius Gost 20287. Acid Number Gost 11362 -1 Mg Koh/G. Tribological Characteristics At 20+-5 Degrees Celsius On A Cmm: Wear Scar Diameter (Di) - 0.31 Mm. Density At 15 Degrees Celsius - 881 Kg/M3 Astm D4052. Delivery Is Carried Out According To The Schedule: Until April 1 - 1500 Liters, Until August 15 - 1500 Liters. Total 3000 Liters, Turbodiesel Oil 15W-40 Avangard, Technical Characteristics Of The Quality Of Motor Oil For Diesel Equipment Brand: M10g2k Compliance With The Requirements: 1) Degree Of Purity, Mg Per 100 Tons Of Mass Not More Than 450 2) Base Number, Mg Per Koh Per 1 G. Mass Not Less Than 8.0 3) Sulfate Ash Content Not More Than 1.15% 4) Viscosity Index Gost 25371 Not Less Than 0.5 5) Mass Fraction Of Mechanical Impurities 0.015% 6) Self-Ignition Temperature Not Less Than 0.5 7) Content Of Selective Solvents 0.5% 8) Density At 20°C G/M3 Gost 3900 Not More Than 0.900 9) Pour Point °C Not Higher Than Minus - 18°C 10) Mass Fraction Of Water % Mass Absent. Delivery Will Be Carried Out According To Schedule: Until April 1 - 1500 Liters; Until June 10 - 1500 Liters; Total - 3000 Liters. (Packaged In 5 Liters), Oil Tad-17 Gost 23652-79. Kinematic Viscosity Mm2/S At 50 Degrees Celsius - 110-120, At 100 Degrees Celsius Not Less Than 17.5. Viscosity Index Is Not Less Than 100. The Temperature Celsius Is Not Higher Than -28 Degrees. Mass Fraction % No More Than: No Mechanical Impurities, Phosphorus - 0.1%, Sulfur - 1.9-2.3%. Density At 20 Degrees Is Not More Than 907 Kg/M3.
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
