The Subject Of The Order Is The Successive Delivery Of Aggregates For The Needs Of The Chełm Commune Within 2026, I.E. Purchase With Loading, Transport And Unloading In The Chełm Commune. The Basic Scope Is Estimated To Deliver 2,500 Tons Of Aggregate, Including: 1. Crushed Aggregate Fraction 0/31.5 Mm - With A Dusty And Clay Fraction Content Of Max. 10% - 100 Tons;2. Crushed Aggregate Fraction 0/22 Mm - 400 Tons;3. Concrete Aggregate With A Fraction Of 0/63 Mm - 2000 Tons; The Minimum Amount Of The Benefit Is 2000 Tons. The Amount Of Individual Aggregate Fractions Is Estimated And May Change During The Execution Of The Contract. The Final Quantities And Type Of Fractions Ordered Will Be Determined Each Time By The Ordering Party Depending On Its Current Needs, While Maintaining The Minimum Amount Of Service Indicated Above. Quality Requirements For The Order: 1) The Aggregate Should Be Homogeneous, Dry, Without Admixtures Of Clay, Clay And Metal Materials Such As Nails, Wires Or Other Contaminants That May Damage Vehicles Traveling On The Road, As Well As Other Hard-To-Decompose Contaminants (Plastic, Rubber, Etc.).2) The Rock Species From Which The Aggregate Is Obtained Should Be Durable And Resistant To Weather Conditions.3) All Materials Must Have All Necessary And Required Approvals, Certificates And Approvals For Use. The Ordering Party Does Not Allow The Admixture Of Marl, Chalk And Limestone - And The Delivered Aggregate Must Have The Approvals, Certificates And Quality Certificates Required By Law Corresponding To The Pn-En 13242 Standard Or Equivalent.4) The Aggregate Must Have Appropriate Test Results Confirming Compliance With The Relevant Standards (Pn-En, Pn Or Equivalent, I.E. Those Whose Parameters Are Not Worse Than Those Indicated In The Standards) And Approved For Trading And General Or Individual Use, Compliant With Technical Approval And Relevant Technical Regulations (Technical Specifications). The Delivered Aggregate Must Have A Declaration Of Aggregate Performance Properties Marked With The Ce Mark, Which Indicates That The Manufacturer Takes Responsibility For The Compliance Of The Product With The Declared Performance Properties And For Its Compliance With All Applicable Requirements Allowing Its Use In Road Construction.
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
