1. Generator Set (2 Pieces) Manufactured In The European Union With A Rated Power (Prp) Of 45Kva/ 36Kw (In Accordance With Iso8528) And An Emergency Power Esp Of 49.50Kva/ 39.60Kw (In Accordance With Iso8528) With An Automatic Control Panel. 2. The Unit Is Placed In A Housing Resistant To Weather Conditions. 3. Housing Adapted For External Installation, Reducing The Noise Level To 60 Db(A) From 7 M (Galvanized With A Thickness Of At Least 20 Microns, Fully Screwed, Not Welded, So There Are No Places Weakened In The Paint Coating By Overheating Of Welds). 4. Lockable Housing, Equipped With Lifting Hooks. 5. Stage V.6 Exhaust Emissions. Industrial Engine, Complete With Cooling System, Injection With Automatic Speed Control, Electric Ignition And Battery Charger,7. Engine, Diesel, Turbodiesel, Liquid-Cooled Engine 8. Engine With Prp Power Of 41 Kw, Stand-By Power Of 46 Kw,9. Generator (Industrial, Brushless Generator With Automatic, Electronic Overvoltage Control System Avr, Self-Excited), Protection Class Ip23, With Automatic Electronic Voltage Regulator Avr, Static Voltage Regulation Accuracy 1.0 ±%,10. Generator With Power In Mode (Prp) 45 Kw, 11. Generator With Power In Reserve Mode (Esp) 49.50 Kw,12. Daily Fuel Tank With A Capacity Of 160 Liters Located In The Frame Of The Unit, Enabling The Unit To Operate For Over 14 Hours At 100% Load From One Tank Filling (Combustion At 100% Prp Load, I.E. 11.3/H),13. Tank With Electronic Fuel Level Sensor, 14. Engine Oil Drain Pump,15. Fuel Leakage Retention Bowl, 16. Fuel Decant Filter, 17. Electronic Engine Speed Controller,18. Electronic Voltage Regulator Avr,19. Automatic Coolant Heating System, 20. Battery Disconnector, 21. Anti-Vibration Shock Absorbers Installed Between The Frame And The Engine-Generator System,22. Residential Type Exhaust Silencer With Reduced Attenuation (-29Db(A),23. Main Switch With Short-Circuit And Overload Protection For The Generator, 24. Lockable Housing,25. Rain Cover,26. Crane Hooks.27. Power Generator Meeting The Stage V.28 Exhaust Emission Standard. Sockets On The Generator Housing:• - 3-Phase 1X63a 5P Feeder Socket• - 3-Phase X32a Feeder Socket29. Ball Hitch With Safety Indicator31. Steel Frame, Fully Hot-Dip Galvanized Wheels35. Preparation Of The Structure For The Installation Of The Generator36. Lighting: The Power Supply Cable Should Be Selected In Accordance With The Planned Load. Filling Of Grooves, Repair Of Walls And Ceilings After Piercing And Installing Culverts,42. Installation Of Covers For Installation Channels, Measurement Of Insulation Resistance, Measurement Of Short-Circuit Loops, And Measurement Of The Short-Circuit Loop In The Acceptance Documents. Protection Against Electric Shock.45. Prepare An Electrical Diagram Of The Connection Between The Facility And The Generator. 46. Location Of The Generators In Two Locations: - Białogard Commune Office Building, Ul. Wileńska 8, 78-200 Białogard, The Switchboard Is Located Approximately 15 M From The Locati
