Quotation are invited for Supply Pumps Delivery Date: 2026/03/13 Delivery To: Area L - Pump Stations Delivery Address: 1 Area L Pump Stations, SWARTKLIP Closing Date: 2026/02/25 Closing Time: 04:00 PM Description: 3 each x supply pumps Specification: * Supply pumps Pump data Solids passage 100 mm Discharge/ Suction diameter 100 mm/ 120 mm Impeller type: Vortex Impeller diameter 285 - 225 mm Recommended min. flow 6 l/sec (21 m3/h) Weight 255 kg Motor Mains: 50 c/s 3 phase Rated shaft power 16.0 kW Rated electrical power 18.8 kW Nominal speed 1450 rpm Motor efficiency 85 % Power factor (cos phi) 0.78 Degree of protection IP 68 Isolation class F (155°C) Max. water temperature 40°C Standard cable length 10 m Materials Pump casing Cast iron GG 25 (EN-GJL-250) Impeller S.g cast iron GGG 40 (EN-GJS-400-15) Motor unit Cast iron GG 25 (EN-GJL-250) Shaft AISI 431 Alt: AISI 316 Bolts AISI 316 Elastomers Nitrile (NBR) or neoprene (CR) Alt: viton (FPM) Electrical cable Neoprene (CR) Seal lubrication Oil Seal pump side Silicon carbide silicon carbide Seal motor side Carbon - Ceramic Coating Two components polyurethane Contact details Nolubabalo Mtotoyi 021 400 6079 0733451629
[email protected] Delivery address: Raapenberg Depot, Off Raapenberg Road Mowbray IMPORTANT: QUOTATION CONDITIONS: The quotation condition listed below are in addition to those contained in the CCT standard quotation conditions and must be fully complied with: Clause 3: General Obligations 3.6.1.1 For this quotation, purchase orders / works packages will be determined and created as follows: 3.6.1.1.1 Based on the total amount as reflected on the Price Schedule and to the supplier as awarded by the SCM delegated authority. GUIDELINE: Wherever reference is made to any Trademark, Name, Patent, Design, Type, Specific Origin or Producer, such reference shall be deemed to be accompanied by the words "or equivalent". CLAUSE - 2.14.1 & 2.15 Provide, on request by the CCT, any other material that has a bearing on the quotation offer, the suppliers commercial position (including joint venture agreements), preferencing arrangements, or samples of materials considered necessary by the CCT for the purpose of the evaluation of the quotation. If the Specifications require the supplier to provide samples/technical data sheets, these shall be provided strictly in accordance with the instructions set out in the Specification. If such samples /technical data sheets are not submitted as required in the bid documents or within any further time stipulated by the CCT in writing, then the bid concerned will be declared non-responsive. The Municipal Bidding Document 6.1 is attached, to be eligible for preference points bidders are required to submit a duly completed, current dated MBD 6.1 document with supporting documents with every RFQ submission, failure to submit will result in zero-point allocation. Please note that the MBD6.1 document is valid a year from date of signature. Failure to comply with the above will result in a zero (0) allocation for preference points. INSURANCE DOCUMENTS: Ensure that all required insurances such as your Public liability, Employers liability or COIDA and motor vehicle insurance are attached and that they are up to date. Nolubabalo Mtotoyi 0733451629 Tender Link : https://web1.capetown.gov.za/web1/procurementportal/RFQ/Details/317297
