Tenders Are Invited For X-Ray Fluoroscopy Devices – Package Inspection X-Ray Integrated Into A Light Commercial Vehicle

X-Ray Fluoroscopy Devices – Package Inspection X-Ray Integrated Into A Light Commercial Vehicle. Acquisition Of Package Inspection X-Ray Equipment (Ccei-2023-Hu-Bcp) Integrated Into A Light Commercial Vehicle. The Main Components Of The 1 Pc System To Be Purchased: • Light Commercial Vehicle As A Carrier Vehicle, • Package Inspection X-Ray Equipment Built Into The Cargo Compartment Of The Carrier Vehicle, • Controller (With Control Panel) Built Into The Cargo Compartment - Designed For 1 Person, • Image Analysis Software For The X-Ray Image Analysis Center. The Package Inspection X-Ray Equipment Must Be Located Between The Drivers Cab Of The Light Commercial Vehicle And The Controller In The Cargo Area. The System (The Carrier Vehicle, The Package Inspection X-Ray Equipment And The Controller Designed For The Operator) Must Be Completely New, Flawless And Undamaged. 1. Package Inspection X-Ray Equipment Requirements The Package Inspection X-Ray Equipment Must Consist Of The Following Components: • X-Ray Unit (X-Ray Source Emitting Ionizing Radiation And Detector Subsystem), • Inspection Tunnel, • Conveyor Belt, • X-Ray Image Display Monitor, • Control Panel With Which The Equipment And Image Analysis Software Can Be Operated, • Image Analysis Software, • Emergency Stop Stop Button (Which Stops Both The Conveyor Belt And The Beam Path It Stops At The Moment Of Pressing), • Beam Path Indicator Light And The International Dial Sign Of Radiation Hazard, • Security Camera System With Its Own Monitor. The Radiation Produced By The X-Ray Unit Should Be Able To Penetrate At Least 28 Millimeters Of Steel. X-Ray Unit Resolution (Wire Detection): 36 Awg Minimum. During The Warm-Up And Operation Period, The Dose Rate Must Not Exceed 1 Μsv/H At A Distance Of 0.1 M From The Accessible Surface Of The Equipment, Or The Proportional Amount Measured At A Smaller Distance (E.G. 4 Μsv/H At 0.05 M). The Size Of The Test Tunnel Should Be Between 800-1100 Mm X 800-1100 Mm. The Load Capacity Of The Conveyor Belt Must Be At Least 45 Kg. The Parcel Scanner Can Only Be Operated When The Light Commercial Vehicle Is Stationary (E.G. When The Parking Brake Is Applied). 2. Energy Source Requirements The Maximum Operating Parameters Of The X-Ray Tube Must Not Exceed 180 Kv In Terms Of Voltage And 6 Ma In Terms Of Current. The Mains Electrical Connection Of The Device Is 230V Ac± 10%. All Functions Of The Package Inspection X-Ray Can Be Operated From The Generator Installed In The Light Commercial Vehicle Or From The Generator Powered By The Service Engine. The Aggregator/Generator Should Ensure At Least 6 Hours Of Continuous Operation For The X-Ray Equipment. The Noise Level Of The Aggregator/Generator Must Not Exceed 78 Db. The Equipment Must Have An Uninterruptible Power Supply, Which Ensures That The Equipment Can Be Shut Down Without Damage Or Data Loss After The Power Source Is Cut Off. 3. Controller Requirements The Controller Must Be Air-Conditioned And Fit At Least One Person. The Controller Should Have A Control Panel That Ensures The Full Operation Of The X-Ray Equipment, Such As The Following: - Switching The Equipment On And Off, - Two-Way Operation Of The Conveyor Belt, - Changing The Magnification Of The Displayed Image, -