Tenders Are Invited For Purchase Of A Slurry Tanker For Transporting Liquid Waste

1. The Subject Of The Order Is The Purchase And Delivery Of A Used Slurry Tanker For Transporting Liquid Waste2. Technical Description Of The Structure: 1) Brand New Slurry Body, Manufactured In 2025, 2) Cylindrical Galvanized Tank With A Capacity Of 5,000 To 6,000 Liters, 3) Full Anti-Corrosion Protection Of The Body, Elements Painted Separately Before Installation, 4) Waste Tank Painted Inside And Outside, 5) Tank Placed On An Intermediate Frame, 6) Barrel Inclination Angle 2-3 Degrees, 7) Liquid Level Gauge Pvc Pipe With A Diameter Of Min. Ø60 Mm, With Connections For Cleaning From The Top And Bottom, Covered With A Stainless Steel Sheet That Can Be Cleaned Without Disassembling,8) Led Work Light In The Rear Part Of The Structure, Covered With A Protective Basket, Illuminating The Work Area Behind The Vehicle - Min. 1 Pc. 9) Two Led Work Lights Placed On The Side Of The Vehicle, Illuminating The Right And Left Sides Of The Bodywork 10) Led Light Bar With A Width Of Min. 150 Cm In Orange Color Mounted On The Roof Of The Cabin,11) Led Warning Light In The Rear Part Of The Body With A Protective Basket,12) Rear Lamps Of The Vehicle Protected With A Cover,13) Contoured Wrapping In Accordance With The Homologation,14) Mechanically Opened Bottom,15) Mechanically Adjusted Bottom With Min. 6 Bolts,16) Oil-Resistant Seal Between The Tank And The Bottom,17) Rear Bottom Equipped With A Handle For Transporting Suction Hoses,18) In The Rear Bottom, A Suction And Drain Port With A Gate Valve Dn 110,19) A Suction And Drain Valve And A Side Suction Valve (Right Side) Terminated With A Firemans Connector Dn 110 Equipped With Transport Caps Attached With A Chain,20) Hydraulically Driven Compressor With A Capacity Of At Least 680 M3/H, Adapted For Continuous Operation,21) Suction Depth Of At Least 6 M From The Ground Level,22) Compressor Located Above The Chassis Frame,23) Automatic Lubrication,24) Vacuum Safety Valve Set To 0.8 Bar,25) Safety Valve Overpressure Set To The Range Of 0.5 Bar26) Built-In 4-Way Manual Valve For Vacuum/Pressure Changes,27) Pressure Gauge,28) Cut-Off Valve Protecting Against Overflow,29) Float Valve Located Inside The Tank With Double Balls, Lower Float Valve Located Above The Compressor,30) Combined Silencer And Oil Separator With A Drain Valve With A Capacity Of Min. 50 Liters Painted In The Color Of The Tank With A Drain Valve,31) Air Filter - Protecting The Compressor Against Volatile Impurities,32) Indicators And Switches Signed With Water-Resistant Stickers,33) Switches On The Panel Waterproof In The Ip67 Class,34) Hooks For Suction Hoses Made Of Aluminum Or Stainless Steel Sheet Mounted On Both Sides Of The Barrel Along The Entire Length With A Width Of The Largest,35) Frost-Resistant Suction Hose Dn 110 - Min. 7 M With A Suction Basket At The End, 36) Frost-Resistant Suction Hose Dn 110 - Min. 7 M Finished With Flanges.3. Chassis: Used Car, No Accidents: 1) Gvm Maximum 12 Tons2) Year Of Production Min. 20133) Mileage Not More