Common Procurement Vocabulary: Cpv 50800000-3 Various Repair And Maintenance Servicescpv 50000000-5 Repair And Maintenance Servicescpv 45500000-2 Rental Of Machines And Equipment With Operator Support For Construction And Water And Civil Engineering Works. Ordering Party: Kruszwica Commune. Completion Date: 11 Months From The Date Of Conclusion Of The Contract. 1. The Subject Of The Order Includes The Equation Municipal Roads Using A Road Grader And Compaction With A Self-Propelled Roller.2. Profiling Of Dirt Road Surfaces Using A Motor Grader On Roads (Dirt, Gravel, Cinder Blocks). Profiling Of Municipal Roads Involves Correcting The Cross-Section Of The Road And Leveling Its Unevenness In Order To Improve The Drainage Of The Surface. During Grading, The Grader Should Remove Transverse Irregularities And Smooth Out Potholes And Ruts, And If Ponding Water Is Found, Make Drainage Grooves.3. The Ordering Party Reserves The Right To Commission Work Only With A Road Grader Or Only With A Road Roller, Depending On The Needs Occurring On A Given Road Section, I.E. Only Works Related To Surface Profiling Using A Road Grader, Without The Need To Perform Compaction With A Roller, Or Vice Versa - To Commission Only Compaction Of The Surface With A Road Roller, Without The Use Of A Grader. The Decision In This Respect Will Be Made Individually And Communicated To The Contractor By The Employers Authorized Representative Before The Commencement Of Works On A Given Section.4. The Contractor Is Obliged To Remove Stones, Debris (Over 5 Cm In Diameter), Etc. That May Be Torn Out From The Surface Of Profiled Roads. Due To The Different Types Of Surfaces And The Varying Degrees Of Surface Damage, The Number Of Grader Passes Should Be Adjusted To Obtain The Appropriate Road Profile.5. The Total Length Of Road Sections Subject To Profiling With A Road Grader Is 300 Km.6. The Total Length Of The Sections To Be Compacted With A Road Roller Is 300 Km.7. The Detailed Location Of The Roads Covered By The Order Is Presented On The Map Constituting Annex No. 6 To Swz.8. The Contractor Must Have Equipment Approved For Operation In Accordance With The Applicable Legal Provisions Enabling The Execution Of The Order.9. The Minimum Width Of The Graders Blade Is 3.60 M, The Minimum Power Of The Grader Expressed In Horsepower Is 120.10. Minimum Weight Of The Self-Propelled Vibrating Roller Min. 10 Tons11. The Ordering Party Reserves The Right To Limit The Order For Road Profiling With A Motor Grader To 170 Km Of Roads And To 170 Km Of Road Roller Work.12. Road Profiling Should Be Performed While Maintaining Optimal Road Surface Humidity.13. During The Implementation Of The Works, The Contractor Will Comply With Occupational Health And Safety Regulations. The Contractor Is Obliged To Secure And Mark The Area Where Works Are To Be Carried Out On The Road. The Vehicle Performing The Work Should Be Marked In Accordance With The Regulations To Ensure Road Traffic Safety.14. The Contra
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
